Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Get 20% off switches when you combine Cisco solutions

 
Labels

Forum Posts

On the FWSM there is an onboard console port, on the ASASM were is it located.After upgrading the ASASM from 8.5 to 9.0 the ASA-SM is not responding at all and shown as unknown in the show module command.  the status led on the module is RED.  tried ...

Hello I have some non cisco routers running vrrp between three sites (Router 1, Router 2, Router 3.  The same server vlan resides at all three sites.  Currently spanning tree is blocking the link between Router 2 and Router 3.  I want to attach two n...

bmoore222 by Level 1
  • 356 Views
  • 1 replies
  • 0 Helpful votes

Resolved! VRF Routing Issue

Hi guys,I'm having problems implementing a vrf on a 3560G (12.2(55)SE9, C3750-IPSERVICESK9-M). I have a number of SVI's configured on the switch and I want to separate routing from one (to start) vlan from the rest.I think my config looks ok, but whe...

nigel doe by Level 1
  • 770 Views
  • 2 replies
  • 0 Helpful votes

Hi there, I hope someone can help me. I don't have much experience with switches, I'm doing the desktop support in our company.We have Catalyst 4510 R+E to 2 Catalyst 2960 switches and seperate VLAN's for IP Phones and for Internet in one part of our...

Hi ,I am trying to configure syslog server ip address on my nexus 5k. I was able to add 1 syslog server ip but when i am trying to add another i am getting error like "session currently owned by a different user" and i am unable to add it.any help wo...

Hi,does anybody know the required license for 3560-x in IOS 15.2E fo use of IP SLA.Cisco feature Navigator does not know yet, configuration guide says at least IP Services license needed, switch CLI permits configuration with LAN Base License.So what...

I'm trying to setup two Catalyst 3750X-48T-L switches to support redundant networking.  Most pieces of equipment will have two Ethernet interfaces, each on separate subnets.  So far, I've got the switches configured as separate VLANs, connected toget...

n.bedbury by Level 1
  • 7665 Views
  • 9 replies
  • 0 Helpful votes

I have captured a packet generated by CPU which is a Keepalive packet with source Index of 0x380(896) and destination index of 0x0(0).When I decoded I found the source index which is 0x380 indicates RP CPU(MSFC) at slot 5 but I am not able understand...

Hello, I've been trying to solve an issue with internet connectivity. Can't ping any website from my Laptop that is connected to Cisco 871w router and this router is connected to Motorolla modem. I can ping any website or my laptop directly from a Ci...

hi there,I was hoping with some advice, we are looking to upgrade the switching and wireless infrastructure in one of our factories. The current setup is:-Core: 2x Cisco 4506 chassisDistribution: 8x Cisco 3560 PoE switches linked via OM2At present WA...

Hello again.I had a question for the community that maybe someone can assist with. We have a 6509 that acts as a DHCP server for all devices. Recently it appears that printers that are set to DHCP have been losing their assigned IP's way before the l...