Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Get 20% off switches when you combine Cisco solutions

 
Labels

Forum Posts

Experts, I work at an airport and we offer free wireless. We have about 20 AP's that are configured for the free wireless. Recently, I've been receiving alerts via Solarwinds that all 20 AP's have high CPU (> 80%). I performed a Wireshark on one of t...

Resolved! 2960S and REP

Hi there,I have recently purchased a number of Cisco 2960 S-24TD-L switches and would like to know if they support REP (Resilient Ethernet Protocol). I have set up a development space and have telnet'd on to one of the 2960's to try and configure an ...

Hi,I want to create small network as attachment below using Cisco Catalyst 3750-X Series :Device 1 have 2 LAN InterfaceInterface 1 to Catalyst LAN A (10.80.3.235/28)Interface 2 to Catalyst LAN B (10.80.3.245/28)Device 2 have 2 LAN InterfaceInterface ...

Attached is the diagram:Scenario : Currently we have connectivity between Switch 1 (Layer3) & Switch 2 (Layer 2) though 1 gig Port-channel 29. Switch 2 is connected to ASA 5585 through port channel 25 where the L3 is created.Now the issue is we want ...

Hi All, I have configured wccp on my 2811 router for the topology as below the "redirect in" command is applied on the router's interface connecting to the core switches, everything seems to work except that i cannot see a particular ip 10.6.1.xx to ...

Hello all,I want to set up a dhcp-relay.There are 2 routers one is the dhcp server the other one is the forwarder.Please see the attached file (from Cisco packet tracer).The pc on the right side only give my a message with a failure of retrieving a i...

boe boe by Level 1
  • 1659 Views
  • 8 replies
  • 0 Helpful votes

Good Afternoon,I am having a little difficulty getting the 819 HGW ISR to work on a GSM SIM from T-Mobile.  How do I "enable" the cellular interface and is that even what I need to do/start with?  Doing a few show commands, the router does see the SI...