Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

 
Labels

Forum Posts

Hi Everyone,I connected two switches together  via below config Switch Aint gi0/1switch mode access switchport access vlan 10Switch Bint gi0/1switch mode access switchport access vlan 10They work fine with above config.I did the Test below However wh...

mahesh18 by Frequent Contributor
  • 1150 Views
  • 7 replies
  • 0 Helpful votes

I understand that when pc's communicate they send arp requests. So when pc A wants to communicate with pc B it sends an arp broadcast and the switch will broadcast it to all on the connected ports to all the pc's connected to it until pc B responds s...

Hello ExpertsCan someone please take a look at the output of our interface and let me know how to determine the following over one hour:Average bps Min/Max Average bpsMin/Max Average Percent UtilizationTotal Bytes TransferredAverage Packets per secon...

Hello, I am new to Cisco routers, and trying to figure out what is needed to complete my router setup. Currently, I have a Cisco 1941 router, with a VWIC3-2MFT-T1/E1 card installed in EHWIC 0 slot. I have two T1 lines connected to it. I have an ether...

please could you explain when we creat a VRF , why  we can see the VRF config (address-family ipv4 vrf x ) in BGP configuration ?

Hi All,I need some advise on the following design.I am designing a campus network using routed access with OSPF. I will have 3 tiers - core, distribution and access. I am looking to configure the core/distribution links in OSPF area 0 and then the di...

de1denta by Participant
  • 1121 Views
  • 6 replies
  • 0 Helpful votes

Hi,we just got 10 new devices with the actual fw 1.0.6.2.Two problems were coming up ...First: user and password ... The other SG 200 switches allow password with special characters like !? ... the SG 200-08 does not! That is not very helpful.And we ...

the vtp password is send as a md5 hash value in the vtp advertisements.but the hash value is computed using only the password or it is computed using some otheer field also if yeh then which fields

Hi ExpertWe have got one new WS-C3750X-48T-E, without any connection, now the CPU utilization is 11%, is it normal or too high? Software version is 12.2(58)SE2, We have another Cisco 3750G-48TS-E, with connection it is just 6%.Detailed configuration ...

Echo Chan by Beginner
  • 931 Views
  • 3 replies
  • 0 Helpful votes