Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Get 20% off switches when you combine Cisco solutions

 
Labels

Forum Posts

HelloI will be replacing our current single chassis (WS-C6509) with the (WS-C6509-E) chassis.  What I want to do is just take our line cards from our current chassis below and place them in our new chassis.  Considering we are moving the Supervisors ...

monty4952 by Level 1
  • 454 Views
  • 1 replies
  • 0 Helpful votes

Hi, Im configuring a switch model WS-C2960G-48TC-L and GigabitEthernet0/45 - 48 which has both RJ45 and fiber port available. I'm connecting to the RJ45 port and i'm wondering if there is any special command required because i cant get the port worki...

Hello everyone,I would like to verify what is the actual boot image running on my  catalyst 6503 E SUP 2T.My IOS is s2t54-adventerprisek9-mz.spa.151-2.sy.bin and my Rommon is ok with the version 12.2(50r)sys3.I tried many command without any success....

claude1966 by Level 1
  • 19623 Views
  • 10 replies
  • 0 Helpful votes

Greetings,I'm relatively new to Cisco networking and very eager to learn everything I can. Currently the company I work for is undergoing a remodel and expansion. The office building I am in has opened a suite on another floor so employees who are di...

DaleHutch by Level 1
  • 666 Views
  • 6 replies
  • 0 Helpful votes

Hi all,After an inspection of the italian authority i need  the "declaration of conformity" of cisco 2621xm and cisco 2811.  Where can i find it ?Consider that i have gave the following documents, but for the italian authority are not sufficient.Can ...

drascii77 by Level 1
  • 1943 Views
  • 3 replies
  • 0 Helpful votes

We have configured a 2960G-24TC-L (Lan Based) switch up with IP address/default gateway (VLan 9) etc and it appears in our network and any device we connect to it has network access but we cannot communicate with it.We use Cisco 2960s IP Based switch...

owens by Level 1
  • 656 Views
  • 5 replies
  • 0 Helpful votes

                   The above is the port status of a problem port , we've connect and Access point to this port . It shows 25650input errors and 8559 CRC error, is it a cabling problem or the port is faulty , what does it means?

Dears please could you help me ? in my c3750 i put 3 port to the portchannel  , and the portchannel has traffic of 2 gigbps , and  i see in the Solarwinds that this portchannel has   1000 trasmit  packet discard i can check what for solving that ?

So I am trying to get the FastEthernet 1 interface on my two 4500-X switches configued with a management VLAN IP. I have configured them with an IP Address and have the switchport they are connected to set to an access switchport for the management V...