Showing results for 
Search instead for 
Did you mean: 

Forum Posts

qos on asa and where to apply it

Hi All,Does ASA have the capibility to tag and add dscp field to packets ?Also where do you suggest I should apply policing or shapping? closet to the source ?for instance to limit all vlan traffic on asa 5505 interface inside to outside to 300kbps d...

Random44F by Beginner
  • 2 replies
  • 0 Helpful votes

NVRAM: Unable to read configuration

I am facing a problem while saving the configuration on Cisco 3750E. When i try to save below error appearswrNVRAM: Unable to read configuration. Try again later.The switches are in stack. So i checked the configuration lock message as well, It says ...

Cisco 6500 VSS power supply question

Hello everyone!I have a question about the possible outcome or behaviour of the power managmet during a power supply failure on a 6500 VSS.Our costumer core switches consisting of two 6509-E in a VSS.Here is the output of Show Enviroment and Show pow...

Can't console to ME3600X

Hello,we have a new one Cisco ME 3600X series,problem in console, some unknown symbols on the screen,telnet is ok,I tried to change everything is possible in line con 0, but nothing happens.Tried to set all types of speed, baudrate, stopbits, parity....

Resolved! InsufficientFreeMemory on WS-C2960-48PST-L running c2960-lanbasek9-mz.150-2.SE4.bin

I've recently upgraded one of our WS-C2960-48PST-L switches to IOS c2960-lanbasek9-mz.150-2.SE4.bin and 'm seeing an "InsufficientFreeMemory" alert on MEM [Processor] module of the device, raised by LMSshow processes memory does suggest a potential p...

Router 3925 boot itself

Hi, End user has a new 3925 router with c3900-universalk9-mz.SPA.152-2.T1.bin. Today the router boot itself and the following reason is shown.Router#sh verCisco IOS Software, C3900 Software (C3900-UNIVERSALK9-M), Version 15.2(2)T1, RELEASE SOFTWARE ...

Resolved! VLAN Access map problem

Scenario is :vlan 210 must not access vlan 250vlan 210 can access other vlans - 200, 914 and vlan 68i tried to permit the addresses of the 3 vlan - 200,914 and 68 on vlan 210 filter, but what happened is it cant also access the 3 other vlan eventhoug...

jumbo frames and lacp with openfiler

hi all,i have 2960 and i enabled jumbo frames but after that my openfiler 2xnic won't bundle anymore with lacp, status will be (I) or stand alone.interface GigabitEthernet0/1 description opefiler1 switchport access vlan 181 switchport mode access swi...