Switching

 we are in process of updating our network. looking for high speed core. server traffic is on different vlanso is voice/ datawe are 98% VM  /SAN is running on seperate Fiberfuture: looking into deploying Virtual Desktop as well as over VPNlook at get...

Hi, i want to setup multiple site to site connection, between my headoffice and remote offices.on HeadOffice, i've cisco router 2821, with IOS model:c2800nm-adventerprisek9-mz.124-20.T.binThere is no extra hardware module on this router, and i want t...

HiI've recently deployed PBR on catalyst 3850s and everything looks to be working ok. However I'm not seeing hits on the ACL or Route-map. I'm using the following commands to try and see hits: Show access-listShow ip policy - to check its appliedShow...

     I am configuring VLANS on 2960x switches by building.  We have about 15 buildings and would like to have each building be in its own VLAN.  This issue I am having is that we have some devices that are static IP's and when those devices are pluge...

Hello All, with just a Cisco router and switches in place with the Cisco router handing out IP addresses to clients is it possible to configure the router to re-direct every new connection to a specific web page for every initial connection (basicall...

I recently implemented a Cisco 1941 router and Cisco 2960 switch into my home network.  My network is designed as follows:Cable Modem > Cisco 1941 > Cisco 2960 > Linksys wireless routerI have a webcam that works over WiFi so it is connected wirelessl...

Good morning -I have a pair of 6513 in a VS40 (VSS quad sup) connected via L3 MEC to a VSS pair of 4500X. Active to Active and Standby to Standby connected in a L3 MEC port-channel that is also a vnet trunk:(Core)interface Port-channel5description Di...

PVID is a command in Huawei switches that mark all the untagged paquets of that port with the VLAN 350. I want to check if Cisco has something like that, 'cuase I need that a Huawei AP goes through a Cisco switch to its controller to register, but wi...

I am getting following logs in my core switch. Invalid mac addres and its coming from different ports and yes it can't be traced. Mar  5 15:04:16.732 UTC: %C4K_L2MAN-6-INVALIDSOURCEADDRESSPACKET: Packet receive                                        ...

Hi allFrom some days ago we experimenting some management problems on C2960X stack. I see these strange messages on log:Mar 10 12:30:31.808 UTC: %XDR-3-XDROOS: Received an out of sequence IPC message. Expected 0 but got 4 from slot 2. -Traceback= 42D...

I'm a bit puzzled about what exactly the "boot-mz" files are needed for on C6500 SUP32 and SUP720 platforms.  Are they really mandatory, or do they serve just as backups in case the main IOS image (or the flash media it resides on) gets damaged?  Sho...