Switching

Hi Guys,Need some help with my 2801 router. After I power down the router it keeps on booting on rommon mode. I need to type the "reset" on rommon then the router loads the image .. Readonly ROMMON initialized.. then boots the image  then user mode.....

Hi,Can we  on the same network use Cisco Catalyst 2960 and Cisco SGE500 switches and share the same VLANs ?

I am trying to connect two different networks together. The networks live simultaneously in a network closet, so I do not want to Connect then with a VPN.Both networks have their own ISPs and should remain that way.One network uses an ASA5505 base se...

Hi,Port security is enabled on our edge switches. When a new IT equipment is deployed, I want other techs to log in to the switch and take care of the port security violation. But I want the techs to have limited access to the edge switches when perf...

I've been trying to configure a test enviornment for a multicast scenario.--(192.168.1.1)--(MCSRCRTR)--72.72.72.0/24--(MCRTR)--205.176.20.0/30--(MCRTRRP)--205.176.30.4--(MC_RCVR)---2.2.2.2I did a test ping on MCSRCRTR by 'ping 239.0.0.10 source 192.1...

Hi, I recently purchased the RV180 router and right now it acts as the NAT gateway of my network. My questions is, what is the proper way to assign let's say 5 public IP address to 5 machines inside LAN?The router has LAN IP of 192.168.1.1 and public...

Hello all,     I have reconfigured the FEX numbers attached to a Nexus 5548 running on NXOS5.2  If I do show running-config the interfaces are not there anymore.  But if I do show startup-config the old Fex interfaces still shows up.  I did try write...

Hi all,A very simple query here. Just looking for some feedback and examples of peoples thoughts regarding this.When issuing domain IDs VSS' in a single organisation at what number do you start issuing from? Do you start from 1 or 255 or somewhere el...

We are currently experiencing random multicast data dropouts on ports that are connected to a 3750X in VLAN ports.A test PC was connected to a routed port and we do not have any dropouts of the multicast data.We also took a 2960G and plugged it into ...

Scenario:Pure 3750X-48PS ip base stackOne switch reboots from a power issue (possibly the master switch? Haven't confirmed yet in the 3 cases I've seen)The rest of the stack stays running fine (as it should), the rebooted switch rejoins the stack jus...

Dear all,We created a policy-map to rate limit traffic on a RSP720-3C-10GE card.Traffic must rate-limited to 5Gbit, but when we test it with 9Gbit all the traffic is allowed.(we see the 9G leaving the router on an outgoing interface)Can it be the cas...

Hello,i'm not sure, but i think i heard once that it is possible to switch (not boot!) to ROMMON mode during a fully loaded/bootet IOS with some Key sequence.Is that correct or am i mistaken? If so, to what platforms does that apply to? And where can...