Switching

Hi everyone,I am working on a design that will see VSS implemented in the distribution and core of a campus network design. My plan is to use a layer 3 port-channel between my two VSS (dist/core) and run a IGP between the two. Vlans for each area of ...

Hi ,We have WS-6509-E and I have noticed this it loaded wrong image. below is results of show version:Cisco Internetwork Operating System SoftwareIOS (tm) s72033_rp Software (s72033_rp-JK9O3SV-M), Version 12.2(17d)SXB11, RELEASE SOFTWARE (fc1)Technic...

Hi,I'm wondering first if I am correct in reading this Cisco Validated Design configuration as limiting everything but ef/cs3 to 10 Mbps on the example interface. So effectively all traffic to/from say, a workstation plugged into this switch, or a wo...

Hi all ,We have configured this switch as root for vlan a and vlan b(example) . But in one vlan i am able to see this switch is the root . whereas other vlan is not showing. But both BID and RID mac address denoting the same switch ...Logs as below ....

Last friday twice our 6509 VSS pair became unresponsive and took down a site for 2 minutes each.Proc utilization was high 99% but for no appearent reason, no normal log messages.I did find some major issues in the sea_log, but not sure how to read th...

Would a difference in the network QoS cause the vPC not to come up? As you can see below, the Network QoS (MTU) are different. If so, how do I change these values?Thank Yougfvvv    Legend:        Type 1 : vPC will be suspended in case of mismatchName...

Dear All,I am always struggling what is supported in which version.Is Inter VLAN routing a standard feature of IP Base or do I require IP services. ? Currently using C2960S (IP Base) ; do I require other platform.?Is there a good overview (document o...

Hello,I have a Cisco Catalyst 4500-X connected to an ISP lan to lan link. This link does exclusively L2 transport.As per my company needs, I have to transmit my local vlans to the remote sites located behind this L2 link. To do so we chose to use Q-i...

Hi all,I have a question about WAN internet speed connections.My Dutch company has a 10Mbit WAN connection with Hong Kong.Ping time <-> 206ms. But my copy speed HKserver2NLserver is only around 47Kbit/s I now it will not be 10Mb/s but only 47Kb is a ...

Hi,Is it possible to simultaneously log to more than one syslog server at a time with v15 IOS on a CAT4506E?Regards,Jake

Hello everyone! As the subject suggests I have a question regarding the speed configuration of a VLAN interface. I first saw this yesterday after our monitoring system notified a high load on the interfaces. The show interface vlanxx command displays...

I am having difficulty getting these two to play nicely. My router has 128 memory and 32 flash. Thr card has a solid light until the ios finishes booting and then it dims. I have the 12.4T advanced enterprise ios. Exact IOS escapes me right now but a...

Hi guysI am building CCIE home lab now, is that ok to use C3750-24TS-E V05 instead of 3560? Do I miss any features for the exam if I use 3750?