Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Dear Friends,I have 2 cisco 2959 switches & both are same version and same configuring. When I login in web based, switch_1 is not show deshboard, and switch_2 is showing deshboard,And even I upgraded the IOS version in switch_1 still dashboard is no...

Hi,Is it possible to block outbound traffic on a layer 2 interface? While still allowing incoming traffic? If so, which commands would I use?In essence, I want to place two ports on the same VLAN, where one port accepts traffic and the other sends tr...

HelloI currently have the following VLANs on my 3560 Switch with IP Routing Enabled. All VLANs can and need to communicate with each otherWhat i want to do is have all my VLANS route internet based traffic to our CISCO PIX IP-10.10.1.101 which is on ...

Hi All,Just a quick one, I am little bit confused with the following subnetting question.192.168.8.33/23Need to calculate the following:No of Hosts:No of subnets:Network ID:Subnet mask:Actually they asked me in an interview.Any help will be much appr...

Hi everyone.I strongly need your assistance of this: The cisco 3550-emi switch that i have in my lab just stopped entering USER MODE (router>). The router boots quite alright but the moment it ask me to "press the return key to get started" and when ...

hello experts,I have a Cisco 2921 route and on  my dayly check I found an error in the log. also I decoded the error but I couldn't get any useful information, this is the 2nd time that am getting this message from last Feb. please refer to the belo...

I have a nexus 5548 that I have recently tried to upgrade the NX-OS on. During the upgrade process, the switch is suppose to reboot itself and load up the new version when it has been installed. However, it has since not been able to do so. I keep ge...