Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Get 20% off switches when you combine Cisco solutions

 
Labels

Forum Posts

Hi experts,i just configured a C6K VSS with Sup2T, 15.1SY IOS software and a WS6724-SFP module with the follwing cos config:auto qos defaulttable-map cos-discard-class-mapmap from  0 to 0map from  1 to 8map from  2 to 16map from  3 to 26map from  4 t...

ingoh by Level 1
  • 304 Views
  • 1 replies
  • 0 Helpful votes

I inherited a network where the PCs were assigned to VLAN 1.  Running Cisco Voice on another VLAN and other things on various other VLANs.  I have always been told that VLAN 1 should be for network management only.  Is there a real downside to having...

HELP! , I'm a newbie learning this networking stuff. I have a good working knowledge of TCP/IP networking. I have a Cisco 3660 router I'm wanting to use in place of a WRT54G router with my Charter cable internet service. I saw a youtube video where a...

Back2life by Level 1
  • 4866 Views
  • 21 replies
  • 0 Helpful votes

What is required to implement MacSec on client side?I just watched the webinar on configuring the MacSec and saw that the host was using the NAM configuration utility and AnyConnect Secure client.  Are they required to implement MacSec to client? Als...

Hello,With the recent release of Cisco 3850 to support One PK, just wondering if this can be enabled for OnePK out of the box. I believe the IOSd release is 15.x and just wondering if there is any guide available to enable the switch for OnePK. Also,...

Hi AllI have a very easily answered question.I have noticed on a 6509 I am working on, that when I do a "show mac-address interface gx/x" no mac address comes back.If I do a show arp | i x.x.x.x the ip/mac shows up, and from there if I do a show mac-...

N W by Level 1
  • 508 Views
  • 2 replies
  • 0 Helpful votes

Hi Everyone, We want to set the "deny all" policy on our network and only allowed ports will only be permittedOn my topology , I only put the DHCP Server and the client for the sake of isolation and ease of troubleshootingI have  3 VLANS, vlan 200 - ...

HelloI read that there is a limit of 128 spanning-tree instances per switch if using PVST, and that any instances greater than 128 do not us spanning-tree.Does the switch indicate that the 128-instance limit has been reached?  Or do you just need to ...

Hi Allcan some help me i have Linksys SRW208P but during configuration password become entered wrong so now i am un able to access on SRW so some tips through which i can reset the password is it possibel pleaseKumail

HelloI'm having trouble with VLANs and can't pin point where the problem is. Up until now, I've only been using the default VLAN1 on my wired network.I have a 877W which used 2 vlans for WLAN, but everything else, all wired devices resided on VLAN1 ...

when i am trying ping , the reply is too slow and packets are dropping ,could any one help what the reason behind this drop and reply is too slow.i am having one core switch and 4 access switch , and core is having two vlans and two dhcp pool , my pc...