Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Get 20% off switches when you combine Cisco solutions

 
Labels

Forum Posts

I know Terminators are used to avoid signal bounce in the BUS topology but I want to understand how the signal bounce can happen in Bus topology.Please help me to understand clearly with technical notes.. you can post on Electronics terms also to und...

Morning All,I am currently carrying out upgrades on switches throughout a site at the moment, all going well until i have come accross this particular stack.I am recieving the following when trying to load an image from a .tarLRC1_2960S_Stack1#archiv...

Hello everyone,I have switch WS-C3750X-48. It runs the IOS version Version 12.2(55)SE5 (C3750E-UNIVERSALK9-M).I enbale ip multicast-routing distributed, but I cannot enable multicast/pim on any SVI in configuration mode. PIM sparse or dense modes are...

Hello everyone,I know there is a way to set load balance on etherchannels and its based on mac/ip source/dst addresses.But is there a way to set weights for different interfaces? Similar to EIGRP.This is for 3560x and 4500Thank youSent from Cisco Tec...

mario_kmc by Level 1
  • 2493 Views
  • 5 replies
  • 0 Helpful votes

Hi I am stacking 6 Catalyst 2960 SF Series PoE 48 ports, I am using the Bladestack cable. I plug it in from 1 to 2 on all the switches. If I look at the lights it shows 4 in on group and 2 in another. If I do a show switch detail it shows the followi...

Hi Everyone,Say i am  tracing IP 172.30.x.x  from switch Sw1.SW1  shows Sh route showsGateway of last resort is 172.22.101.3 to network 0.0.0.0S     172.16.0.0/12 [1/0] via 172.24.101.1Need to confirm i should choose next hop to destination   via  17...

mahesh18 by Level 6
  • 573 Views
  • 2 replies
  • 0 Helpful votes

                   Hey Guys, I had a question about a certain set-up that is coming up. We have a small office going live soon and the set-up is as follows. Our network connection coming in will be linked to a Cisco ASA5505 that will serve as a DHCP ...

Hey all,I've got a catalyst 3550-48T switch that is having post problems. From power on all ports light up green and status flashes green. After one second the status light changes to solid amber, port 1 is solid amber and the other 47 ports are soli...

I have an ASA 5505 in a very simple setup with just 3 vlans - mgmt, internet and LAN. I have some servers in the LAN.Since I have started using ASA 5505 (I had an untangle firewall before), I noticed thart SSH'ing to the servers on the same LAN has a...

Review Cisco Networking for a $25 gift card