Switching

Hello,could you please tell me how i can setup a BGP protocole with BFD ?Best regards---Posted by WebUser Jamall Haddann from Cisco Support Community App

Simple question, prob already know the answer but I want to be sure...Does it matter as far as performance and/or redundancy if you connect the switches via the stacking cables in a crossed fashion with one link connecting the top and bottom switch o...

Hello all,I've recently connected a previously unused interface from our F5 LTM to our 3560G switch.  I have the LTM interface and switchport interface both in the same VLAN.  However when I do a "show mac-address-table int g0/48" the interface doesn...

Was hoping someone could help me here.We have just purchased a large number of these to provide edge access to lecturns.The uplink switch ports are configured as trunks (as are the switches they connect to). VTP mode is set to client.The first couple...

Can anyone tell me why I am getting these inconsistent traceroute results fromone switch? Why does switch 172.23.31.8 trace fine to 172.23.30.1 but switch172.23.31.6 is sent to the default route when tracing to 172.23.30.1 ?See attached diagram. Than...

Hello I have a 4510 Switch that is used as the Core Switch for the network, there are two  4516-10GE cards. As well as four 48 port blades, I would like all four of the gigabit uplinks on each of the 4516 cards to be active. The Ten Gigabit uplinks a...

Hello !Not shure - but I think it must be very simple ...I like to redirect requests to port 993 from IP1 to IP2. Both IP Adresses are public and in the same network. From a getway network they are routet - so I think at this point it mus be possible...

Hi,I'm trying to run 2 vlans on a lab network.I've a network 10.180.0.0/16 for this purpose in that I'm already using in my internal dhcp server. Static addressess for server are form 10.180.128.0-254/16 scope and clients are dynamic from 10.180.140....

                   The topology as above:      Wireless users can get IP address (10.10.1.0/24) from R1 and wired users get it (10.10.2.0/24) from R2.      Now I enable dhcp snooping on the two routers .G3/3 of two routers are set by trust port . G1/...

Hello team,Can you please help me to provide the minimum required DRAM& Flash for the IOS images listed below? I've checked on this using Cisco feature Navigator& google, but no luck.c2900-universalk9-mz.SPA.151-4.M6.6.binc2800nm-advipservicesk9-mz.1...

Hello,  is it possible to check the FIB TCAM utilization of a Catalyst 4948E?  There is a command on Catalyst 6500 platform (show platform capacity forwarding), but I couldn't find any similar one for Cat4948E...BR, Attila

I have a problem on a port on my 4948.It has the following configuration:switchport access vlan 250 switchport mode access switchport port-security maximum 3 switchport port-security switchport port-security violation restrict speed auto 10 100 spann...