Switching

Getting the below error.This is a 4507R+E switch running with WS-X45-SUP7-E  supervisor. IOS version is  cat4500e-universalk9.SPA.03.02.00.SG.150-2.SG.bin. Kindly help here to resolve this error messages.000975: *Dec 10 00:19:04.233: %SFF8472-5-THRES...

Switch automatically restarts for no reason , I have upgraded the software.can not find fault. more crashinfo, see the following output:------------------------------------------------------------------------------------------------------------------...

A 4506 Switch  reboot several times a day for no reason,  I have been trying to upgrade the software . Normal operation of more than ten days ,  Still there reason to restart . cpu and memory usage is normalSwitch output information below, please hel...

hi all,Our Customer used Distribution switches are DistSW4507-01 and DistSW4507-02. These switches used HSRP with Dist-02 is active, Dist-01 is standby.But, the past few days then the CPU of Dist-01 increase to 60%, you can see result as follow:DistS...

Dear all,I was wondering if someone could help me with class B /17 and 18 subnetting i don't understand how the octets increment i find subnetting easy on class C now but get confuse with increments with class B. . I would appreciate if you can provi...

HiI just completed a lab installing a TFTP on my server, saving the router startup config and reinstalling it after erasing it on my router. The issue is, i had my gateway as 10.10.10.1 on g0/0. after reloading the DHCP on my server assigned g0/0 10....

We have an environment where users create a lot of bridge loops.  We have tried to send E-mails about it and educate the users but it is almost a lost cause at this point.  The loops are created when users don’t pay attention and they plug a patch ca...

Hello allI wonder if i can have 2 switches configured as VSS and to connect a third switch with HSRP configuration ?**************************                               *********************                              *                         ...

D    172.16.0.0/16 [90/297246976] via 192.168.13.3, 00:07:45, Tunnel0297246976 is a low bandwidth, large delay, is it possible to improve this ?Router1#sh ip routeCodes: C - connected, S - static, R - RIP, M - mobile, B - BGP       D - EIGRP, EX - EI...

Hello ,I have NM-16ESW card installed in one of my 3845 router. Below is the sh inventory outputNAME: "16 Port 10BaseT/100BaseTX EtherSwitch", DESCR: "16 Port 10BaseT/100BaseTX EtherSwitch"PID: NM-16ESW          , VID: V01 , SN: FOC11482484NAME: "Gig...

HiI have 2 internet connections and I have seprate address pools for these connections. I applied PBR on each interface of switch to route the data based on source ip pool.When I apply this PBR on interface suddenly latency increses from 2ms to 55ms ...

Every time I try this our wireless AP controller goes down and our wireless bridge goes down.Here is what I have;  Cisco 2100 Series Wireless Lan Manager with 6 access points for our two wireless networks.  Cisco Aironet 1300 Wireless bridge for our ...