Switching

HiI just completed a lab installing a TFTP on my server, saving the router startup config and reinstalling it after erasing it on my router. The issue is, i had my gateway as 10.10.10.1 on g0/0. after reloading the DHCP on my server assigned g0/0 10....

We have an environment where users create a lot of bridge loops.  We have tried to send E-mails about it and educate the users but it is almost a lost cause at this point.  The loops are created when users don’t pay attention and they plug a patch ca...

Hello allI wonder if i can have 2 switches configured as VSS and to connect a third switch with HSRP configuration ?**************************                               *********************                              *                         ...

D    172.16.0.0/16 [90/297246976] via 192.168.13.3, 00:07:45, Tunnel0297246976 is a low bandwidth, large delay, is it possible to improve this ?Router1#sh ip routeCodes: C - connected, S - static, R - RIP, M - mobile, B - BGP       D - EIGRP, EX - EI...

Hello ,I have NM-16ESW card installed in one of my 3845 router. Below is the sh inventory outputNAME: "16 Port 10BaseT/100BaseTX EtherSwitch", DESCR: "16 Port 10BaseT/100BaseTX EtherSwitch"PID: NM-16ESW          , VID: V01 , SN: FOC11482484NAME: "Gig...

HiI have 2 internet connections and I have seprate address pools for these connections. I applied PBR on each interface of switch to route the data based on source ip pool.When I apply this PBR on interface suddenly latency increses from 2ms to 55ms ...

Every time I try this our wireless AP controller goes down and our wireless bridge goes down.Here is what I have;  Cisco 2100 Series Wireless Lan Manager with 6 access points for our two wireless networks.  Cisco Aironet 1300 Wireless bridge for our ...

Hi, i would like to block all Web Trafic for my LAN, and i using my switch Cisco 2960.i tried to do that with access list :deny tcp any 192.168.1.0  0.0.0.255 eq 80but it don't work, can you give me an idea ?

**** I have this posted in another forum section but this forum section seem more appropriate *****I have no idea what I am doing, lets get that right off the bat.Simply stated... I have a Cisco 2811 Router. I have two VLANS on the router. The first ...

Hi there,My questions is can a 4 port PoE switch module (EHWIC-4ESG-P) and a 8 port switch module (EHWIC-D-8ESG) be used at the same time in a Cisco 1941 router?Thanks in advanced.Robin

Hi Guys,what would cause "Total output drops"? we have been seeing calls drops on ip phones. most likely because of this.interface GigabitEthernet1/0/7 switchport access vlan 2 switchport mode access switchport voice vlan 201 srr-queue bandwidth shar...