Switching

HiI am using cisco packet tracer to configure the hsrp on 3560 (c3560-advipservicesk9-mz.122-37.SE1.bin)but the standby ip Command is not available on the interface ,  the problem in that IOS or in config

We have a Cisco 3845 router configured as a voice gateway with multi SIP trunks. But when it reachs 200 calls traffic, the CPU increase to 60-70% and caused by CCSIP_SPI_CONTROL process.CPU utilization for five seconds: 46%/30%; one minute: 54%; five...

I have cisco switch ws-c3560x-48 run with ios c3560e-universalk9-mz.150-1.SE2.bin.I try to snmpwalk for dot3InPauseFrames with OID 1.3.6.1.2.1.10.7.10.1.3 but I cann't receive any value.I think my IOS cann't support EtherLike-MIB, anyone can tell me ...

Hi,I gonna configure a new termial server for connecting 13 of my datacenter devices, but the data centre quite big and all devices far from TS like more than 100 to 150 mts.I am yet to order for cables which is going be used for connecting all devic...

Hi out there,I try to configure ip helper redundncy on a interface in a vrfint gig0/0ip vrf forwarding testip address 10,10.10.1standby 1 ip 10.10.10.254standby 1 name testiis the initial configwhen addingip helper-address 20.20.20.20 redundancy test...

Anyone know the answer to this?I'm not having much luck looking around, unless my search criteria is off.Thanks!                  

we have two cisco slm2024 switches and one 3com (also supports stp and portfast configuration) 24 port switchwe have 4 servers all connected using gig to the 3com switch all the workstation, servers and printers are connected to a combination of all ...

In the process of upgrading the image for all of our floor switches..In total there are 35 WS-3560G-PS switches.So far I have been upgrading them all to image c3560-ipbasek9-mz.150-2.SE2.bin and that has gone well.But this eve 2 of the switches are e...

Hi teamWe have 2 cisco 6509 switches with SUp2T and configured in VSS.The IOS running on the device is ( Image Version = Cisco IOS Software, s2t54 Software (s2t54-IPSERVICESK9-M), Version 15.1(1)SY, RELEASE SOFTWARE (fc2))when we try to configure VSS...

Greetings!I have a Cisco 1801W router, running a DSL connection with wireless connectivity for a school.This is configured on the fastEthernet0 interface on the 192.168.1.0 network (the router is 192.168.1.1).I was wondering if it is possible to get ...

Hi,We bought a pair of ASR 1004 to be installed at Primar & Secondary data center and one thing is to run OTV over it, but to do that, I have to extend multiple VLANs from my Core (Pair of Nexus 7010s) connected directly to the ASR is Primary Data ce...