Switching

I have a 3750 and when I configure a trunk port I cannot set the port: switch port mode trunk as I do in the 2960If I type switchport mode ? On the 3750 I see ......AccessDot1q-tunnelDynamicPrivate-vlanTrunkUnder the 2960 when I do the same I getAcce...

I got the following from a show ip mroute mcast-group:#sh ip mroute 224.0.15.34 count IP Multicast Statistics1577 routes using 919202 bytes of memory705 groups, 1.23 average sources per groupForwarding Counts: Pkt Count/Pkts(neg(-) = Drops) per secon...

All,When attempting to configure a test ACL to log hits to the ACE "permit ip any any log" so I can view what ports are being used for connections into a vlan I received the following message from the switch, " The log keyword is not supported on ACL...

Hello,Attached you'll see what I need:- Two distant LANs have to communicate through a Layer-2 WAN with fault-tolerance (hence the stacked C2960).- On each side I have 2 VLANs (2 and 3) and a management VLAN (50) in order to manage layer-2 devices wh...

Hi,Is there a way to create saved sessions in Putty that can be imported  into a different machines?Thanks, Pat.

Hello all, please could you someone help me about this issue (critical for me...)My company bought the PAK for the advanced IP services feature. Actually I'm using the Evaluation type.Using the Cisco License Portal I got by email the new license.lic ...

I have no issues when I use only pc in the port, it gets authenticated and works fine.When I connect a PC via a polycom phone then it gets error disabled.It will go to error disable only when I connect the (PC and polycom) together & at once I connec...

Hi,my two HO router is connected in MPLS cloud behind HO1 router web server 1 is connected. i want from MPLS cloud any branch (A, B or C) when want to go to WEB SERVER-1. HO-1 router should be replicate that tropic to WEB SERVER-2 which is behind con...

HiI have 2 ISP connected to Router A and Router BBoth the routers are connected to the core 3750 switch.. I want to send the traffic from the switch that goes to router A to router B...I have done the following but its not working...vlan 120 = 10.120...

HiI have a 2 ISP One Hooked to router A and the Other to B both are hooked to Core switch 3750. The Port on the switch where the Router is connected is No switch Port and I have given the IP address.3750 - has the PBR templatedI would like to use PBR...

I have a problem with my 2610 router. I have 2950 switch connected to the 2610 router using trunk connection. On the 2610 router when i assigned IP addres 192.168.0.1 to the interface e0/0 i am able to ping 192.168.0.2 -  my Vlan1 interface on the Sw...