Switching

Hi guys, one last question before my network change this evening. Your input is valued as I'm not 100% comfortable with the change being remote from the site the changes are occuring at.My scenario is this: I have a 6509 running 12.2(18)SXF10 and a r...

I have cisco router 800 series 887 VAW. WiFi is connected to all my devices through this router, i.e.,  Windows XP,  Vista, Wii, Nexus 7 and HTC Desire S. I can access internet from all these devices. The apps which are already downloaded on my Andro...

I am creating an extended access list in cisco 3560 as belowpermit ip 10.65.1.0 0.1.255.255 host 10.0.0.1permit ip 10.65.1.0 0.1.255.255 host 10.0.0.2 permit ip 10.65.1.0 0.1.255.255 host 10.0.0.3But when I see the ACL by show ip access-list the subn...

Hello, I have a  WS-C3750G-24T-S layer 3 switch and I need to configure independent routes for a specific network, I'm trying to use VRF but it is not working for me. I tried using route-map but it seems the switch doesn't support that, so I'm stuck ...

Hi everyone !I'm just wondering how can be the behavior of the "ip directed-broadcast" command when the interface get a ip packet in 255.255.255.255 ?I understande that the command allow the "explosion" of a directed-broadcast address in the subnet d...

Hi all.  I have a non-Cisco router and it has no sensible capabilities.  There seems to be a spam botnet on the internal network (unknown which are infected systems).  This router cannot do port blocking from inside to outside and my goal would be to...

Is there any way to keep an SVI up (in this case, an L3 vlan that exists purely for vPC+ keepalives) without burning a physical port for it?From what I can see, a fabricpath connection does not keep SVIs up the same way that a typical trunk or access...

Dear All,hope you are all doing well,I need your kind support to troubleshoot my new design as you can find it in the attached file,the setting of the up-link interfaces as below: plz find the blow seting for the up link interface on  SW_Ainterface T...

I have a VPN on my ASA 5510 between (A)192.168.255.0/24 and (B)172.20.2.0./24. The purpose of the tunnel is to send kerberos tickets from our domian controller on the A side, across to a server at B, and receive a respose. I want to lock down inbound...

Is there some kind of trick to getting the fastethernet 0 management port to come up? My adjacent switch is up/up, but fe0 is down/down. I dont' see how this could be possible. I am getting all my info remotely, but I am pretty sure it's wired up cor...

Hey, it seems that ever since we converted the 3750 from a L2 to a L3 switch with 'ip routing' that we have been getting the following messages while doing 'show logging'%CMP-5-NBR_UPD_SIZE_TOO_BIG: Number of neighbors in neighbor update is 128, maxi...