Showing results for 
Search instead for 
Did you mean: 

Forum Posts

I got my esx servers service console nics on trunk ports. how do I get dhcp/pxe working on these trunk ports to a specific vlan on bootup?

Dragomir by Beginner
  • 9 replies
  • 0 Helpful votes

Hi:I have 2 Nexus 7K in a VPC Domain and a 6509 acting as an access switch.I want to vpc the 6509 to the 2 Nexus.Let's say domain is already created.For the downstream link going to the 6509.On the Nexus:switch(config)# interface gig 4/1switch(config...

Hi ,i have a switch cisco WS-C6509-E WS-X6716-10G-3C module ( module for 10 GB) , i have the IOS s72033-ipservicesk9-mz.122-18.SXF9.bini want to know if this IOS can support this module or not ??or ,  if i must do a upgrade , is that the  IOS : "s720...

Hi All,Easy question here.  I have a Cisco 2960 48-port switch.  I enter "sh vlan" and it lists all the VLAN's.  One of the VLAN's listed is "10" with the name "EPIC".  What is the quickest way to find out what ports, if any, are assigned to this VLA...

hello,I am trying to test the MTU between two 3750 switches I have in the lab.  I've set the MTU with the command "system mtu 9000" on both switches and rebooted. The only connections on the switches are the gig ports connecting the two switches.  Ea...

dhalevi by Beginner
  • 4 replies
  • 0 Helpful votes

Dear All,as i know that Mac address reduction allow the switch to re allocate priority field in the bridge ID to be 4 bit for priority and 12 bit to vlan idand without this feature switch will need a seperate mac for each vlan used in spanning tree e...

Hi experts,I have a small problem I am hoping someone can help with.A little background on the network - Core is a Stack of 3 3750's with a number of 3560's in remote area's and 2960's as access switches.I have approximately 15 vlans configured on ou...