Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Hello I have setup two ports with two host conencted to them one with address 10.1.70.2/24 and the other is 10.1.80.2/24. I created two SVIs(VLAN70 = 10.1.70.1/24 and VLAN80 = 10.1.80.1/24).However I am unable to ping the two hosts. Each host can pin...

petey1984 by Level 1
  • 1796 Views
  • 8 replies
  • 0 Helpful votes

Hi all, I've a simple doubt that needs clarificationSwitch AFa0/23 (VLAN 60, access mode). connect to the internet GW 192.168.1.1 mask 255.255.255.0 (for eg). Fa0/22 (VLAN505, access mode).PC B - connected to VLAN 505- IP address 192.168.1.100 config...

Hello everyone,I'm starting my career as a Cisco engineer and have some doubts about certain infrastructure topics.This is the situation I'm facing in the company I'm working at currently:The company is replacing old routers and switches, and revampi...

stamac706 by Level 1
  • 4700 Views
  • 2 replies
  • 0 Helpful votes

Studying Ospf, and periodic flooding i found that ospf refresh it's LSA every 30 minutes (1800 seconds) if no change occur, but the output of my show ip ospf database shown an age of more than 1800 seconds as in the output above from my router 1800 s...

Hi Everyone,Hope someone can advise me. I am new to using Nexus switches.I have to connect a Nexus 5548 mgmt 0 port to an out of band switch Cisco 3560.There will be no trunk from the 3560 to our distribution, instead you have the OOB switch, running...

jrtmouton by Level 1
  • 857 Views
  • 1 replies
  • 0 Helpful votes

Hi everybody.When using ipsec (  AH/ESP), both authentication and encryption require a secret key as dicussed in the following extract:                  Authentication calculates an Integrity Check Value (ICV) over the packet's contents, and it's usu...

sarahr202 by Level 5
  • 2869 Views
  • 6 replies
  • 0 Helpful votes

HI everybody   Please consider the following scenario on dhcp snooping on cisco switches.                                rest of network ---------SW1(f1/1-untrusted)-------------f1/2( untrusted) Sw2--------------------Dhcp serverAbove sw1 and sw2 bot...

sarahr202 by Level 5
  • 964 Views
  • 2 replies
  • 0 Helpful votes

Hi there,I tried to upgrade the IOS on my internal AP and now I am in a reboot cycle. I have tried to manually boot the old and new IOS images from the rommon but neither are working. here is the output I am getting:ap: dir flash:Directory of flash:/...

Unanswered Topics