Switching

Hello Experts,Below are the commands I have to run on our PROD L3 Switches and need to know if it could make an impact on services.router bgp 65099 no neighbor 192.168.12.1 route-map prepend-AS in  (Is there any possibility that after executing this ...

Greetings .... I manage a small/medium sized campus network consisting of 4 Cisco 6500 series chassis (each with SUP720's) and a couple hundred Cisco 3550/3560/2960 edge switches. We recently completed a new leg of fiber that will make a completed lo...

Does anyone know the best way to configure NIC teaming switchports for HP servers?Currently we have a problem where servers are connected to the switches in a dual NIC fashion and are teamed. The server transmits out of both interfaces but receives o...

I have a Cisco Wireless LAN Controller WCL2112 model. It's currently plugged into an HP Procurve switch on a trunk port. That HP switch is plugged into my Cisco stack on a trunk port. I can reach the WCL just fine through the LAN. But when I plug the...

Hi,I have configured the port channel for two ports in Cisco 3750 switch. While connecting the cable in that port i am getting the native VLAN mismatching error. Below i have attached the configuration and error details. Please help me on this.Error:...

Hi Everyone,I need help setting up a VLAN. We just bought the SG500x switches and we need to create several VLANs.So for example:192.168.1.x --> Vlan 1192.168.2.x --> Vlan 2192.168.3.x --> Vlan 3What I would like to know is how do I come about settin...

HiI am going to change a running 6500 switch. I am missing a best pratice doc for changing a cisco switch configuration. My question is if a startup-config has an error (due to typo mistake, or due to comands not supported on latest IOS) and I do    ...

Hello,I try to check the "Reactivate Suspended Port" in the port setting on my SG300 switch.After clicking on apply, it comes back unchecked.Please help.

Hi,I am about to implement a new LAN infrastructure for a customer which uses Catalyst 3750X switches for the core/server farm and Catalyst 2960S switches for the access layer.The network will support Cisco 7945 IP phones, softphones (Lync or Jabber ...

Hi i have one question . İn router we cant have etherchannel but if we want to have redundancy and increase speed what we should do?Sent from Cisco Technical Support iPhone App

Hi,I am checking out the licences for NAT444 and NAT64. I see these two licences for the ISM on ASR9K.A9K-CGN-LIC-5M     CGN License Unit for 5 Million translationsA9K-DSLT-LIC-5M  DS-Lite License Unit for 5 Million translationsCGN means Carrier Grad...

I'm trying to cluster two 3560's together and I'm not able to ping the new 3560 cluster member.  When I connect a laptop directly to the switch, I cannot ping or get any data connection.  However, and even though I can't ping the switch, I was able t...