Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Get 20% off switches when you combine Cisco solutions

 
Labels

Forum Posts

Two sites withtwo  switches etherchannel concept for wan linkDoes it work? Please suggestOn switch1--site 1interface GigabitEthernet1/0/1--Wan link1no switchportno ip addresschannel-protocol lacpchannel-group 1 mode active!interface GigabitEthernet1/...

Hi,I want upgrade my switches 2960-24PC-L RAM: 128MB and Flash: 28MB, but in the web page of cisco I see that the requirement of hardware is RAM: 128MB and Flash: 32MB. I download the IOS file and this file is only 11.2MB so my question is if I can u...

Hi Everyone,I have set up vrrp between 2 routers for testing.R1 has this config 2691Router#sh vrrpFastEthernet1/1 - Group 20  State is Backup  Virtual IP address is 192.168.7.3  Virtual MAC address is 0000.5e00.0114  Advertisement interval is 1.000 s...

mahesh18 by Level 6
  • 5691 Views
  • 3 replies
  • 0 Helpful votes

Hi All,I am trying to get my head around layer 2 protocol tunnelling. I assume this can be configured using switchport access mode, switchport dot1q tunnel mode and AToM. In what cases would we need to increase the system mtu of the service provider ...

Good day,I have not enough experience to know if I am configuring things correctly.Basically, we need a network with 5 VLANS divided over 2 layer 3 switches and all devices need to be able to communicate with each other.The interVLAN communication ca...

Hello,I have two C4506 switches and I would like to create two L3 links between them by using only one physical link.I will then assign each L3 link to a different VRF.I think I have two choices but I'm not sure however that the second one is possibl...

jbluciani by Level 1
  • 4169 Views
  • 1 replies
  • 0 Helpful votes

Hi Group,I have scenario for you.One of my client having two branches connecting over Wireless Point to Point link.Just he is extending his LAN from one site to another site using wireless point to point link. Both side he is using Cisco 2960S switch...

When i ping to its on LAN interface ip address i am getting this pattern packet loss.Need to know what could be the reasons and where can i get the documents for further informationThere is not any policy applied on the interface. r-08-in#ping 10.204...

Hi.I''ve trying to bring up ports on a N7K-M108X2-12L card using X2-10GB-SR modules.All ports are in a VDC and configured to accept the M1 card:vdc_id  vdc_name                          state               mac                 type        lc------  --...