Buy or Renew
Buy or Renew

Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
Labels

Forum Posts

Start a conversation

VACL-3750

Hello EverybodyI´m facing to one issue with VACLi have a network lan with 10.40.X.X/16in this network i have a Production vlan 10 with 10.40.10.X/24and i have created one vlan103 for Guest´ user as 10.40.103.X/24My goals is to restric the vlan 103 to...

2960 no internet access from VLAN

I have a 2960-S running the lastest software for testing on my bench:[code]Switch Ports Model              SW Version            SW Image                 ------ ----- -----              ----------            ----------               *    1 24    WS-C...

viningele by • Participant
  • 3489 Views
  • 7 replies
  • 0 Helpful votes

2960G Port Setup

I am going to be connecting my 2960G to another network which will be sending multicast traffic that I need to record on my network.  However, due to the administrator of the network I am connecting to, I am not allowed to send them any of our data. ...

Resolved! Cisco 2600/3640 WIC-2T

Can someone walk me through the steps on how to configure my serial modules on my 2600 and 3640?  Each router has the WIC-2T with two cables connecting them.  I tried to ping one router from the other, but no luck. Serial IP address I just made up, t...

jwood1650 by • Beginner
  • 1913 Views
  • 22 replies
  • 0 Helpful votes

Multicast inter Vlans

Hi guys,I need enable multicast inter vlans, the picture attach, my configuration attach.Can you help me, if my configuration is correct, please? then the IOS version support IGMP V3 by default?Thanks, for you help.

3750X QoS issue

Hi,i recently configured QoS on 3750x (12.2(55)SE1 ip base)to mark packets regarding access lists (here is a config extract)*******************mls qosclass-map match-any testmatch access-group name ACL-Test!policy-map Ports-accessclass test  set dscp...

Resolved! Simple Routing Issue

Afternoon Everyone, Appologies for such a basic question but i'm just getting started with cisco kit so you will have to bare with me.I have a cisco 1841, Fa0/0 has the ip of 192.168.5.20 Fa0/1 has the ip of 10.0.0.1Fa0/0 goes off to the Default gate...

3750G-24TS interface drops

Hi experts,I'm troubleshooting interface drops. However the output of the following show commands don't match number of drops. Based on the output, can you find out what is causing the drops? the G1/0/28 is the uplink. Is that just the port got overr...

Difan Zhao by • Contributor
  • 754 Views
  • 7 replies
  • 0 Helpful votes

Resolved! Port issue on 6509 being replaced by a 3750

I have a 6509 at a remote office that is being replaced by a pair of 3750's (6509 was overkill).  I have a port on the 6509 that is configured like this -interface GigabitEthernet1/1description Riverbed:Inpath 0_0  then to Firewall ip address 10.1.1....

Resolved! Simple DSCP marking

HelloI am trying to set up a simple configuration on a Cisco 4928-10G switch running cat4500-entservicesk9-mz.122-37.SG.binAll I want to do is to mark all trafic on vlan 3 let's say for this example with dscp af31.All outgoing trafic to be marked wit...

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers
Spotlight Award Nomination