Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Get 20% off switches when you combine Cisco solutions

 
Labels

Forum Posts

Hi,We have to connect two 3750G switches to some HP machines. Those machines have several network interfaces, which are going to be configured in several bondings. The load balancing mode they want to configure is mode 6, alb. We have investigated an...

Hello , can someone give an answer?if after having an active peer-link port-channel between a couple of nexus 7010 I change lacp system-priority on both boxes and then I add a new member interface on that port-channel , that interface will be aligned...

Hello Everyone, My old switch software version is c3750-ipbase-mz.122-35.SE5 and model number is WS-C3750-48TS-S and my new switch Software version is c3750-ipservicesk9-mz.122-50.SE5.bin and model number is WS-C3750V2 . I want a compatible (prefer s...

Dear All,I have three routers R1-R2-R3 connected in a network..R1 has the following configuration:interface Loopback0 ip address 10.168.246.11 255.255.255.255!         interface GigabitEthernet0/0 ip address 10.168.254.4 255.255.255.0 duplex auto spe...

Hello,I have some PC which require running in environment with VLAN.  However, some of them could not configure with VLAN tag but some can.  So simple drawingPC (cannot config VLAN) <-----> CISCO 2960 <-----> Server (can support VLAN tag)How should I...

I understand the sub-ints on  aserial WAN link, usually for frame-relay, but why the sub-ints on the fa? And how is it implemented on the LAN?  With a FR switch?R#sh ip int brInterface                  IP-Address      OK? Method Status               ...

The Nexus 5548 is running 5.1.3.N2.1a and has the L3 daughter card (N55-D160L3)I have the EIGRP feature enabled. By the way, when doing a 'sh feature' four EIGRP features show up like this:eigrp 1 enabledeigrp 2 enabled (not running)eigrp 3 enabled (...

jkeeffe by Level 2
  • 2374 Views
  • 1 replies
  • 0 Helpful votes

Hello to everyone,I have a problem with an etherchannel between a cisco 2950 and a couple of catalyst 4506.The  cisco 2950 is connect via an etherchannel to the catalyst 4506A. The  channel consist of two port on both side and is in trunk mode,  enca...

mempireo1 by Level 1
  • 1055 Views
  • 8 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card