Switching

I have an SRW2024P that appears to be passing traffic fine but my network monitoring software shows it to be unpinable and web interface unavailable. It will be up for a couple of minute the down for 5-6 minutes. It is running the latest firmware for...

Hi, I have this configuration on a edge router that connects to the service provider. ----------------------- Current configuration : 285 bytes!interface GigabitEthernet0/0 bandwidth 3000  <<<-------- ip address 172.17.32.254 255.255.255.240 no ip re...

Dear all,We need an extra L3 interface on our newly bought Cisco 2901 router. What specific card we need to be able to have a 3rd interface on the router.Regards,Uniscon

Hi All,We have L2 network infrastructure based on two Cisco Small (one SGE2000P and one SGE2010, both in stacking). We have multiple VLAN for various organization unit and we need authentication of users connected to wired port (users need to move in...

Good afternoon today I want to do a deployment of 2 Nexus 7000 chassis and connect using OTV, so my question is something that is timely: Do I need 2 supervisor  cards in each chassis mounted  of the switches to be supported OTV? regards

Dears I have a Switch  WS-C3750G-24T-E, and I need to know what IOS suport command below!MPLS:no mpls ldp advertise-labelsmpls ldp advertise-labels for MPLS-TAG-LOOPBACKS to LDP-NEIGHBORSno mpls ip propagate-ttlmpls label protocol ldpmpls ipmpls mtu ...

Can any one tell me the speciality of Cisco Nexus swithces ?Does it have a different OS than IOS of cisco catayst switches ? and also coming to configuration commands , are they differ to that of IOS command set.I have seen one nexus config , there i...

Hi everyone,I'm currently setting up a small MPLS network to have a play around with, and i'd like to use IPv6. In IPv4 everything works fine, but when using IPv6 LDP doesn't seem to bind labels to IPv6 addreses?Are there some limitations in the Cisc...

I am trying to decide the best way to setup a multipath network.  Any suggestions are appreciated:I want to route all traffic destined for the Internet from SiteA on PathBSiteA 10.0.0.0 to SiteB 172.16.0.0 on PathBSiteA 10.0.1.0 to SiteB 172.16.0.0 o...

Hello, I have an 1841 router that has a 2xT1 internet connection that we have begun migration off of (it is still active).  We also have a metro ethernet connection on the same router which is connected to our new ISP and all internet-bound traffic g...

Hi,Sorry to make it long. We are in a progress setting up QoS on our branch LANs.In general we have a routing switch (3750 ip services) and access switches (3750 stack with ip base) connected to the routing  swich using etherchannel.Routing switch is...