Showing results for 
Search instead for 
Did you mean: 


Forum Posts

Resolved! Cisco Switch Local Proxy Arp

Hi,We were deploying a ftth solution with cisco equipment (switch 2960 and router 2821). With the Internet providing test, the topology worked great. But when we tried communicating between two hosts, we had to enable local proxy arp in the subinterf...

drojasug33 by Beginner
  • 2 replies
  • 0 Helpful votes

how to upgrade IOS

Hello,1. I have cisco 4503 sup II+TS and there is no external flash in this switch. when I enter show bootflash: and enter it shows the image which is installed. Now it is having 32 Mb of Memory.I have upgraded the IOS of routers and switch which are...

Access list problem

Hi ,I need to apply this to an interface on 2950 switch.access-list 100 deny ip 100 deny ip 100 deny ip 192.168.1....

OSPF protocol gateway??

I have P2P ospf with two router and two router is down or or passive interface default adj. is gone but in sh ip protocol command it show the RID of neighbors? why? and how long should display?RTR1#show ip protocolsRouting Protocol is "ospf 65534"Out...

abhi-adte by Beginner
  • 3 replies
  • 0 Helpful votes

GLBP and HSRP on same switches will work ???

I have two core switches 6500 and i have configured GLBP on vlan interfaces and HSRP on interface gig 1/2 on both switches.1. how the traffic will flow form lan to firewall and firewall to LAN. 2. will glbp work proparly3. do i need to run hsrpplease...

rahul.zip by Beginner
  • 4 replies
  • 0 Helpful votes

Resolved! managment ip for cat 6500

Hi allI would like to use the uplink port on my cat 6500's as like an out of band management port, what is best practice for this? would it be to assign an ip address to the interface itself ?cheers

Resolved! 2960-S and PXE Boot

Before I bought my catalyst 2960-24tc-s, I was assured by sales staff that it had full DHCP functionality.  However, upon unboxing I can find no hint of dhcp service beyond acting as a relay.  no 'ip dhcp pool' command in the cli, no nothing!  the do...

HSRP - ASR / 7507 issue

Hello We have two routers, one is an ASR1002 and the other is a 7507 router. They each connect into separate 6509 (catos) switches which are connected. The 7507 has 6 individual networks connections and each interface is using HSRP.The ASR has the sa...

thstagman by Beginner
  • 3 replies
  • 0 Helpful votes