Switching

Hi Everyone,I just passed my BCMSN exam and I am trying implement a network at my church using 2960 lanlite switches.One of my PCs in the network was having FCS-Errs - I ended up fixing the PC NIC to 100/Full and set the switch port to speed 100 / d...

I am converting a pair of m10s JunOS 7.6R1.9 to a pair of IOS 4948e's. I have done most of the config by hand using the display-set on the JunOS side and engaged my Cisco Sales Engineer, but looking for more info (too much has never hurt anyone!) .. ...

Hi all,I have a small question,we have an nms which is getting the alarms for the stack port down from all of our 3750 stackable switches.We havent connected or configured any stacking and dont want to, as we are using our switches without stack.to c...

Hi,I have three 3750x to be stacked. I have below doubts :As i understood that ,we need not to configure anything for stacking , In that case , how the master selection happens even we have all IOS and hardware identical.we have not configured any sw...

Hi Guys,I am in a bit confused about the working of communication from inside to dmz and dmz to inside.I have a set like this.inside------outside            !            !         DMZI understand tht to allow communication from inside to outside or i...

CertificationSent from Cisco Technical Support iPhone App

Hi every oneRouters by dedault stop broadcast address. Let say we have following set-upLan----f0-Router-S0--------WanF0( ip address)  199.199..199.17 255.255.255.240Let say router receives a packet on s0 with destination ip 199.199.199.31what router ...

Hello,1) These are the IKE logs for attempting to communicate between the twomachines (KamokilaNAS and NimitzAD)The first one is initiating the communication from the NimitzAD side, wherethe IPSec tunnel is built successfully. 2-25: 14:41:23:294:5f8...

I just installed a NM-1GE into me3745 but something seems wrongI can't get any data to pass (I even connected a computer directly and set the interface to an IP of 192.168.200.1 and the computer to 192.168.200.2 and the computer couldn't ping 192.168...

This is the case. We have a IBM blade chassis with 2 * c3120X switches stacked as normal in blade environment.Goal is link aggregation from AIX server to blade switches.We have tried:802.3ad on AIX side - channel-protocol lacp on switch side and mode...

Does the following SUP720 and Routing Module support IPV4/IPV6 Dual Stack mode. 5    2  Supervisor Engine 720 (Active)         WS-SUP720-3B 5  Policy Feature Card 3       WS-F6K-PFC3B      5  MSFC3 Daughterboard         WS-SUP720         IOS 12.2(18...