Switching

Hey guys,Not sure how to search in this forum and I am sure this has been answered before so sorry if this is repetitive.I have a small office and we have recently upgraded to RV4000 router. Since the upgrade our LAN speed is ridiculously slow in any...

I have 2 3560G as core switch but 1 is current as standby in case the first switch fails.I am tasked to setup HSRP on both switches.so that core switch01 is the active while core switch02 is the standby.currently the 2nd switch is not populated.it is...

Hi to all,  I Know that this question was discussed many times, but I didn't find a clear answer and I still can't find any solutions to my issue.I've recently added a second subnet (192.168.2.0/24 in diagram) to the inside interface of my PIX that c...

Hi,I have a stack of 4 no.s of 3750-X switches all switches are currently running IPBase, now i want to upgrade IP service licence on two of them. Could any one please point me towards the documentation to upgrade IPservice licence in heterogenous en...

Hi ,       I need to order a cable forHWIC-1T , which cable should i go for1) CAB-V35FC     V.35 Cable, DCE, Female, 10 Feet2) CAB-V35MT    V.35 Cable, DTE, Male, 10 Feet3) CAB-SS-V35FC   V.35 Cable, DCE Female to Smart Serial, 10 Feet4) CAB-SS-V35MT...

I have a set of Cisco 3524XL switch and a Linksys SRW2024P switch.   When I plug the 4 cisco 3524XL switches directly into the Linksys and VoIP phones off the 3524XL's I get jitter in the converstations, remote desktop becomes choppy on the screen up...

HiI am trying to upgrade the IOS on one of our 6509 switches, with MSFC and Sup2 cards.I downloaded the image onto a new formatted 64Mb flash card. Despite having  half Gb of DRAM and the 64Mb card, on rebooting the 6509 the following error was repor...

Hi All,I have Cisco 3550 switch, on POST all lights flash amber very quickly and stay that way, nothing on the console....Is it possible to fix it? Any ideas?ThanksMarian

I'm trying to use a 64mb flash card in a Cisco6509 sup2 msfc2 - CatOS7.6(9)how can i clear the flash and copy to it? - i've tried with different cards of the same type and same error messagesdir slot0:error = -24open device slot0 failed (bad device i...

hi alli have few cisco swithces and want to check their warrently .plz guide me how to check warrenty of cisco switches .i do have their pin no's.regards

Hi All,I am in an environment where we have a Cisco 4507R core which has gigabit ethernet hooked into our IBM Bladecenter H chassis. Our IBM Bladecenter has 2 cisco switches as the I/O modules for network connectivity. That said, I am having a diffic...

Here we have a 1921 router. Also we have 2 different service providers. we connected them two different Giga por of the router. each ISP have 1:1 transfer rate. Can we combine them to get a transfer rate of 2:2 ? help me to configure the same.