Switching

HelloI have 2 servers ( solaris 10 )  as shown , i need to run load balancing between them to distribute the traffic  .notice that the servers work together .so how i can configure the switch to do this ?what is the switch that i need ?Regards

Hello everybody!I have the following network:I want to make uplinks from 4507 and 3750 always up and Po1 (between 6506 and 4506) as a backup link for vlans 100-4094.I made:1) 6506 primary root for vlans 1-2199 and secondary root for 2200-40942) 4506 ...

So I have a 3560-X running latest IOS.  When I put a input service-policy on a interface and then type "show policy-map interface gig0/1" I never see any of the service-policy  counters increment.  I know the policy is working because I have police s...

Hi,We have a setup where we assign multiple customers into the same VLAN.We do this to save IP space, since most of our customers need only 1 public IP address, so assigning them each a VLAN would be incredibly wasteful.However, we have had issues wh...

Hi,Can any one explain about SPFs of switches ?  are these called GBICs,  What is the exact purpose of this?

Hi,I am having a problem getting the aaa acccount command to actually send any information to the my two ACS 4.1 servers. The servers are showing logs for Tacacs accounting but not tacacs Administration, so i am unable to see what commands my technic...

I'm definitely out of my comfort zone here...but after reading a bit, I think a VLAN setup is what I'm after.  I'd like 2 networks at my house sharing the internet connection. One network for my computers, One network for my kids.  The purpose is sec...

Hi,     Im having a little problem regarding vrrp. May vrrp state for both my core device are in master state. There are no acl between them. I Have set a higher priority on the other other core device but still it is both master. Do you have any ide...

I have two 1721 Routers that are connected via a point to point T1 which connects into a WIC 1DSU T1 card on each of them.  We have had our T1 go down twice and both times one of the routers needs to be rebooted to allow traffic across the network.  ...

My LAN consits of a 2960 switch and a 1841 router. The switch is trunked to the router's Fa2 switchport using several VLANs.There is an ip printer - lets name it P1 -  connected to a switch port on the router, and that switchport is configured as an ...

Hi all,I have implemented pbr on 3750E switch recently. The switch is having 10 vlans and configured with a default route also. After implementing the PBR I am getting some issues on intervlan routing even I am using deny statements. Is there anyway ...