Hi All,Just want to ask, is there any configuration on catalyst 3750 that will allow specific port on only one pc?or in any way is it possible to open a specific port to one pc.thank you and hope you may help me.
I have a 3560 series switch and was wondering about powering the unit 12VDC. I will be mounting this in a solar site for canopy wireless internet. I do not have a inverter for AC power at this time. I would like to keep this site DC. The male por...
I need to configure port spanning for call recording across multiple sites, with "monitored ports" (at remote sites) having a destination on a different switch at a different (central) site. I understand the basic concepts of rspan, but the configura...
Hi Guru's.Cisco 7609S running 12.2(33)SRE2Im running a traffic gen to simulate a bit of remarking on the backbone. I want to remark incoming traffic and then overload it to ensure its dropped on the backbone link. What im finding is that the defaul...
I was asked to set up a port channel from my 4900M to a couple of NETAPP servers, can this be done. There are two gig ports on each servers. Port channels between switches is easy but can it be done to end items. I tried but I counldn't get my Port...
I have a 3560 doing ip routing using eigrp. I have 2 separate vlans, 1 is 10.15.16.0/24, and the other is 172.16.166.0/24. I have 2 separate Firewalls that I want to have dedicated for each vlan. How can I set a default route for the 10 subnet to ...
HiI am thinking on installing 2 stacked WS-C3560X-48T-S switches, however I am wondering what routing capabilities they will have.On the product overview it states 'Routing: Basic Layer 3 static routing with 16 routes', can someone confirm what this ...
We have a wireless network with a Controller 4400 and a Catalyst 2960. Some customers with Intel wireless network cards get a very weak signal while the others get a normal signal.Are there any settings the IT team should check? They are not very pro...
Hi,Let's say I have one switch named SwitchA and we have two vlans, vlan 51 (data vlan) and vlan 722 (voice vlan) configured. In order to view which port is configured with vlan 51, we can use command line as below:-SwitchA>show int statusPort ...
I have a bad 2821 router that is equiped with the CF slot. What is the procedure to backup the entire config and import it into the new RMA'd 2821 router. I'm not onsite so I will have to walk someone over the phone in this process.
First off I hope this is in the appropriate place, and I apologize in advance if it isn't (just point me in the right direction )...In the LAN Switching and Wireless CCNA Exploration Companion Guide, chapter 4: VTP (page 185 in the textbook) states:"...
Hi We just purchased Dell Power connect 6248.Beore we had Cisco 4507R switch as core switch and connected to Cisco 3560 in many floor. Now we are going to install and configure 6248 switch as a replacement for of Cisco 4507R switch. This 6248 switch ...
Hello,We have two areas of the datacenter which are phyically separated (perhaps 250 meters). Up until now these areas have been on two different subnets. However, now we need to start moving some servers from the one area to the other without chan...
