Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Get 20% off switches when you combine Cisco solutions

 
Labels

Forum Posts

When I update the access-list used in a route-map used for a policy-route on my Cat 4507R 12.2(53)SG, there's a significant delay between when I update the ACL and when the change takes affect. I'm guessing it has somthing to do with a certain table ...

rtjensen4 by Level 4
  • 397 Views
  • 2 replies
  • 0 Helpful votes

hi! i've a pair of old 6509 that's connected to a new pair of 6509e. Currently all the L3 routing is at the old core. We are in process of migrating these L3 GW to the new Core vlan by vlan. I've these 2 pairs of core switches connected by a L2 link ...

dkblee by Level 1
  • 387 Views
  • 3 replies
  • 0 Helpful votes

On a 3750, if all 3 options are configured - which option has preference? I'm trying to figure out, how the switch will react if a BPDU is received. spanning-tree portfast bpduguard default spanning-tree portfast default spanning-tree portfast bpdu...

romjones by Level 1
  • 553 Views
  • 1 replies
  • 0 Helpful votes

We have multiple sites all inter-connected with a private WAN which we control the routing. Basically we redistribute all internal networks to the WAN using EIGRP.We are now looking to add another layer of redundancy for Internet access. In other w...

Resolved! 4507R Sup2+ GBIC

When running redundant sups, sup 2+ in our case, is it possible to utilize all 4 GBIC slots? Right now we are only able to use 1/1 and 2/1. i receive this error when trying to edit one of the 1/2 and 2/2 ports.% WARNING: Interface GigabitEthernet1/2 ...

WE have created a route maproute-map test=rm permit 10 match ip address 40 set ip next-hop 10.10.10.10Originally we attempted to assign it to an interface with little suceess and read where we had to do sdm prefer routing. We executed the SDM prefer...

dpatkins by Level 1
  • 557 Views
  • 2 replies
  • 0 Helpful votes

hi! how do i detemine whether a fiber is MM or SM? Will it work if the connector is SX type but the fiber patch cord is single mode type? or will it work if the connector is LX but the patch cord is multimode?We do have quite a few fiber cables that ...

dkblee by Level 1
  • 330 Views
  • 1 replies
  • 0 Helpful votes

Hello everyoneI understand that applying egress queuing on a 6500 gigabit port is very platform and module specific, and in order to achieve that you need to follow the DSCP->CoS->wrr mapping path, and the work on the wrr queues.I have a direct gigab...

Hello everybody,I have a strange and very annoying problem on a switch 3750-48TS with IOS 12.2(40)SE.On each port I have :switchport mode accessswitchport port-securityswitchport port-security mac-address xx..But on one port which was in use before, ...

billetj01 by Level 1
  • 2388 Views
  • 2 replies
  • 0 Helpful votes

can i have a option to track interface in cisco 6509.the scenario is i have 2 links coming from my distribution switch towards this particular switch and 1 uplink isgoing towards the internet.when the downlinks from the distribution are down (line pr...

Review Cisco Networking for a $25 gift card