Switching

Hello,I am trying to bring up three 3560G switches. I don't think they have the StackWise capability like the 3750s but I was wondering if there is a way to have them all act as one switch and thus configure them as one switch.Thanks in advance! Al...

Hi,Just wondered if there is a maximum number of lines on an access-list. I currently have an access-list of around 850 lines on a 4506 switch which is becoming unmanageable. I'm concerned we might reach a point where we can add no more lines to the...

Good Day All!General question....was wondering if that are any known issues with Poe network cameras and the 3750E series. We are introducing network cameras into our business mix and the first camera that was installed looses connectivity every so o...

Switch interface is working ok but interface out it is showing30 second input rate 0 bits/sec, 0 packets/sec 30 second output rate 0 bits/sec, 0 packets/sec

If my ISP were to go offline and the route that I am tracking is removed, is there a way to set a time before it can return to the main line? I know I could simply pull the cable if the line goes down but I am wondering if there is a way to automate...

Hello,I want to configure my Catalyst 3750 to act as a IGMP stub (proxy) in order to forward all IGMP packets rather than participate in PIM.I succeed once, but now it doesn't work anymore...I've been trying to reconfigure it, but without full succes...

Hi,I was wondering if it is possible to give a privilege access and let a person only put a specific vlan ID on the switch port but not all VLAN IDs available on the switch.This is because I had DMZs on the LAN switch, and I don't want to give access...

Any HOWTOs that I can use to configure IPS feature that is included in an Advanced IP Services IOS ? Have a 3800 series router.

Hello, I would like authorize the access in the internet since a cisco router 1760 with according to hours and according to the mac address customers host. Be this possible? If yes how I do have to make?Thanks...

Hi,We have a C6500E with WS-X6704-10GE cards and XENPAK-10GB-LR+ modules.This coreswitch is connected to an EMC Solera SAN, via a catalyst 3750E switch.On the other end, the 6500 is connected to HP bladecenters via CBS3125X-S bladeswitches.For iSCS...

i'm doing some old-school stuff here but for the life of me I'm not getting the routing correct.i have a remote office RTR (1700 rtr) connected to the central office RTR (2851 rtr) via their fastethernet ports.to setup a dial up back up solution i pl...

Hello All, I have a cisco VTP domain setup, incase I decide to add another vendor switch(say nexus/juniper), how can I get them to speak to my core switch as these switches dont support VTP. Manually creating vlan and using dot1q tagging/trunk...

Hi allCan I use loop and root guard with RSTP ?and what is the best practice config for these ?

Hi..I would like to know that How many number next-hop support when I set the PBR at C6509?When I set the ip next-hop in pararel , Is it possible loadbalancing per each next-hop?at conclusion. if you know that, please let me know the link thank in ad...