Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Get 20% off switches when you combine Cisco solutions

 
Labels

Forum Posts

I was trying to follow this document for setting up my Cisco 4507R switch to support multicast mode for a Microsoft network load balancing.http://www.cisco.com/en/US/products/hw/switches/ps708/products_configuration_example09186a0080a07203.shtmlBut I...

jplowick3 by Level 1
  • 743 Views
  • 5 replies
  • 0 Helpful votes

I just upgraded from a CISCO2514 to a Cisco 2611XM for my internet router.Everything is working fine except 1 remote host (FTP server) that I cannot connect to.If I telnet to that server from the router itself, I am fine, but not from remote hosts be...

ppicard by Level 1
  • 391 Views
  • 3 replies
  • 0 Helpful votes

Hi All,I'm drawing a blank with spanning tree at the moment.All ports would be configured as trunks. I have access switches downstream from L3_SW_01 and L3_SW_02 which are trunked rather than routed. With respect to the attached diagram, would I be c...

Does anyone have any tools they would recommend on how to view the current state of spanning tree on the whole network? I have 80 VLANs and about 70 routers/switches. Doing a show command on every device is very time consuming. What is the better ...

jeff.cook by Level 1
  • 1010 Views
  • 2 replies
  • 0 Helpful votes

Hi All,Do get any output from this, what it is and what status failed?State Transition: From Normal To FailedTime Of State Transition: 2009-03-22 00:36:34Probe(s): 192.168.0.204Scandetails:Notification: 0Notification Activated: 2009-03-22 00:36:34Not...

I got some problem on Catalyst 3750G stack and MST. The attach file is the topology.The core switch in the diagram is stacked by Catalyst 3750G-12SS and Catalyst 3750G-24TS, which using 12.2(46)SE as their IOS. The edge switch is Catalyst 2960-48TC w...

I have a 3750-e, without routing or multicast enabled. there are two switch ports which uplink a firewall and router that are supporting multicast. How would one block multicast traffic on ports that don't need multicast and still support multicast,...

ksvy_ksvy by Level 1
  • 2043 Views
  • 5 replies
  • 0 Helpful votes