Switching

Hi,I'd like to confirm that this will work as expected. We are expanding our network. We plan to have a pair of 3825 routers with HWIC-9ESW switch cards installed, to use for distribution of traffic into actual 29xx and 35xx switches. The 9ESW has a ...

ear all,I have 1841 Router with 3 interfaces, one fo r LAN and two for Inrenet as follows:- Fa0/1 used for LAN - Se0/0 used for Leased-Line (1Mpbs) - adsl interface used for ADSL connection (4Mpbs)Waht I need is to limit the traffic Bandwidth which i...

I have set up 1 3560G switch to server as my backbone switch and 3 2960G switches to server my distribution layer switches. i have configured a two gigabyte ether channels from the backbone switch to each of the 3 distribution layer switches but the...

HiI have two l3 switches A & B. A client router is connected to both these switches. No routing protocol will be used between the router & the two switches. ONly static routes are being used. The client router will have a static route for 172.16.x.x ...

Hi All, I am currently testing the PBR feature and i would like to know how it functions. the scenario is the following:we would like to redirect the traffic to SWITCH2 when the destination is an IP from the subnet 10.160.130.0.i am doing the test fr...

Hi, i found "unknown protocol drops" in show interface. Is there any document or clue of that statement?The number of unknown protocol drops increase continuously. I saw it increased whenever i show interface.

We have Windows 2000 Server with DNS Roles to resolve local and internet DNS.The DNS Server is mapped with public IP on the Router and allowed Ports required for DNS Resolution.Our Internet Service provider doesnt have any issues and DNS Server is ok...

Hi All, can anyone explain the nature of the below error and how it can be fixed ?Thanks Jean *Apr 3 21:31:03.069 UTC: %CDP-4-NATIVE_VLAN_MISMATCH: Native VLAN mismatch discovered on GigabitEthernet4/6 (642), with router1 GigabitEthernet4/7 (643).

Hi,We are having 2 lease line connectivity, we are going to purchase "Cisco 2811 AC PWR, 2FE, 4HWICs, 2PVDMs, 1NME, 2AIMS,IP BASE, 64F/256D, and WIC-2T". Any suggestion from expertise..Is this HWIC serial interfaces, whats is WIC-2T component?..Pleas...

Hi,We are having 2 lease line connectivity, we are going to purchase "Cisco 2811 AC PWR, 2FE, 4HWICs, 2PVDMs, 1NME, 2AIMS,IP BASE, 64F/256D, and WIC-2T". Any suggestion from expertise..Is this HWIC serial interfaces, whats is WIC-2T component?..Pleas...

I need to convert a couple of Sup2 6509 switches from hybrid mode to native IOS mode, however all the images of 12.2(18) are bigger than the flash on the SP (only 32 MB). I searched Cisco sites but didn't find a 64MB flash for Sup2. So has anyone run...

Hi All,Can I deploy AutoQOS on my LAN switching and layer 3 switching when using a Siemens VOIP solution. I realise that their phones do not do CDP, so I need to trust the COS on the access port. But can I use all the other AutoQOS settings?Thanks in...

I would like to know if the switch 3560G-24PS has a non-blocking architecture .

What does it means?ThanksPrasad