Switching

Looking for the command to filter multiple lines from a configuration. I found it online a couple of months ago but didn't write it down and now can't find it.I am trying to 'sh run | i ...' where it will show me each interface in the running config ...

hi there, im trying to setup failover between two ASA 5510 and on inter e0/3 (on both ASA's) i have plugged a crossover a cable directly connecting them. Will this work to configure LAN based failover with stateful failover or do I need to connect th...

Hi, I have a customer with a blade center with 2 IGESM blade switches installed. Switch A works fine, however Switch B is giving me a bit of a headache. It's configured identically to Switch A with the exception of IPs/Host name, however when I go ...

I am trying to set up a 2610(IOS ver 12.3(26)) to provide console connections in my lab. When I try to reverse telnet, the 2610 shows the connection opened, but I just get a blank screen. I have read a few previous posts, but they have not helped m...

I am following the password recovery walk through shown here: http://www.cisco.com/en/US/products/hw/switches/ps628/products_password_recovery09186a0080094184.shtmlWhen I get to step 9., Enter "n" at the prompt to abort the initial configuration dial...

Hello,we have a Web Server connected to the DMZ zone in Cisco ASA 5520, this ASA is connected to Two Cisco 3845 Routers each router is connected to a differnet ISP and there is BGP peering configured between the ISPs,also there is HSRP configuration ...

Hi ,I am getting following error message on catalsyt 6500 switch. %QM-SP-4-WARNING: TCAM request associate if=1015, if_type=0 [lkup=1] status:15?? What does this error message indicate.?If any one have a document associated with this error message ,p...

Hi, I'm trying to set up a hub & spoke configuration using 2 spokes. I'm using multipoint sub-interfaces on all routers and frame-relay map commands with the 'broadcast' keyword. My problem is that I am only achieving connectivity between the hub a...

Hi, I have a Windows PC connected to a VLAN ( cisco catalyst 3500 ) switch . The switch has also a DHCP server connected to it. Now when i enable the ethernet interface connected to the VLAN switch ( access mode ) , it takes a long time to get an a...

Hi,I have a Cisco content switch 11501 which has two services configured:service service1 ip address 10.122.193.212 activeservice service2 ip address 10.122.193.217 activeand an owner with a content rule defined as following:owner Owner1 content...

network diagram: 6509------7609 | |2950-1 3500-1 | 2950-26509 VER:CatOS 7.1(2)7609 VER:CatOS 8.4(5)switch interlink protocol is trunk.problem:1、7609 vtp mode is server and domain hyzp.6509 configure vtp mode server.b...