Switching

I understand how the IP helper Address command works and I know that you can have several IP helper addresses on the one router interface.But, can anyone tell me, does the router transmit to all configured ip helper addresses on the one interface at ...

Hi all,i see this on router interface Interface Status Protocol DescriptionFa0/0 up up Fa0/1 up up Se2/0 ...

I have two Switches A and B. Currently, the fibre is connected to only Switch A which is live. Say now i bring in a new Switch B. I try to trunk the fastethernet to Switch A and it works. I am able to access internet through Switch B.1) However, i ca...

I m getting following error in my L# switch. How to rectify the problem.. which leads my network slow..%C4K_EBM-4-HOSTFLAPPING: Host 02:01:00:00:00:00 in vlan 1 is flapping between port Gi5/2 and port Gi 4/22

I have a router which has OSPF area0 and and eBGP configured. I have the subnets such as 10.22.33.0/24 available through my OSPF and they are E2 / E1 routes. Also, I will be receiveing huge number of prefixes in 10.x.x.x range from the eBGP. I would ...

Hello everybody, today i connect a lan with cisco 2600. conecting it to two switches, making 2 subnets, but i cannot ping to the router or to the other subnet. Could somebody help me? I'm studying to CCENT.

by stacking 9 switches which is the limit, should i expect to get the full 32Gbps Backplane bandwidth?How does it work on the 3750 stacking?without the stack, what is the backplane bandwidth on each 3750?does cisco have other stackable switches?

on a 6500 with Polycom stations connected to a PoE switch module:The polycom ip 430 phones support CDP and the switch is normally able to assign them to the voice vlan without any problems. however, we just encountered an issue today where the phone...

Is there an equivalent command in IOS to the following PIX/ASA command?# logging message 111009 level 3The goal is to log all commands entered by the logged in user.Thanks.

We are in the process of redesigning the core.There are several ideas.The one I like the best is:2 6509's720's in eachand bridge the 2 together as one switch, not sure of the exact terminology.Basically want it to look like a switch stack. Admin fro...

hi,i configure Enter prise switching setup. customer already having core switch with 6500 series now they purchased 7*4500 switches for access layer . We configure basic things .. can any one suggest me what are all the configuration we can add apart...

I've got a 3640 router that's connected to a 3550 switch. The trunking is set up as dynamic desirable, and I need to change it to be a dot1q trunk. I'm having a little trouble getting that done. I tried doing a:switchport trunk encapsulation dot1qswi...

Hi,My client, a hosting provider, will be migrating their client to a new network. The servers etc will get another public ip-address. Because some clients have quite a few servers I would like to be able to spread the migration period while still be...

Posted by: musumani.woods - Jul 7, 2008, 4:18am PSTI have four switches, 2 cisco 2960 and 2 dell powerconnect 5324 that are redundant to each other. All switches have a physical connection to each other. Currently when one switch goes down I have to ...

hi,I just want to know if this how eigrp show a feasible successorfor exemple:P 192.168.1.4/30, 1 successors, FD is 29468416 via 192.168.1.18 (29468416/21845248),Serial1/1 via 192.168.1.9 (57912832/21845248), Serial1/0is the ro...