Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Get 20% off switches when you combine Cisco solutions

 
Labels

Forum Posts

We purchased an ASA 5520 last October and have been having problems with uploads speeds since installing the device. We purchased a 6MB up and download line from an ISP. The ASA is set to 10 full duplex and the ISP has reassured me that they are al...

Let explain my current topology briefly and what i am planning to do. Currently i have about 20 3560's that i will be putting into layer 3 and running EIGRP soon. Right now they are in layer 2 connecting to a 4506 which is doing inter vlan routing. ...

cowetacoit by Level 1
  • 1178 Views
  • 11 replies
  • 0 Helpful votes

I downloaded a ios file from cisco site. it is saved on my desktop, what is the easy way to copy it from the dsktp to the router.there is no scp or tftp on my Lan, will establish that later, but for now just needed the easy install.. Thanks

I am seeing allot of ARP requests that looking like the switch (probally something spoofing the switch) is scanning our network and incrementing by one....like something has a virus. Here is what I am seeing in the switch.... Aug 12 19:12:54: IP ARP:...

burleyman by Level 8
  • 340 Views
  • 2 replies
  • 0 Helpful votes

Hi I have a 2950 series switch on which i need to run 2 different span sessions for monitoring but when i give the session id 2 it says not supported can someone help me in this regard is this a bug or a feature of Cat 2950

Hi Experts,I have two internet connections from two different SPs. and they have assigned address block from their pool. I am using SP-B for back up and SP-A as a primary one. I want to use NAT but the problem is when link towards SP-A goes down SP-B...

Hi all, I have 2 css11503's in active/passive redundancy config. When using the commit_redundConfig command the ssl does not copy across correctly. I have cleared the standby box and started again, but with no luck. The config guides I have found off...

Guys i need urgent help i have couple of cisco 4948 but as soon as i turn them on it goes to rom monitor mode.....can you please help me how i am gonna put ios in it i tried on cisco web site but couldnt find it. thanks in advance

Review Cisco Networking for a $25 gift card