Switching

Hi All,I have a Cisco Catalyst 2960 running the LAN LITE image, im having problems applying an ingress policy to limit ingress bandwidth to 3mbps. On a 10Mbps link interface.The sh policy-map int fa0/2 shows no packets being mached using the default...

I downloaded the full zip from http://tools.cisco.com/support/downloads/go/Model.x?mdfid=281795035&mdfLevel=null&treeName=Routers&modelName=Cisco%20Configuration%20Professional&treeMdfId=268437899from the 1st link, but it seems to be corrupt. The 2n...

I need to measure latency between my site and other sites. If I run a series of pings and take the avg of the avg, will that give me a good latency measurement?Also, will I get a legitimate measurement if I measure from logging on to the remote site'...

Hi all ,Please i need exaplnation on multiple access list.I have 2 interfaces on my router and I want to create access list.Bearing in mind the access list :per interface per protocol per direction.How do i implement multiple access list ie ip acces...

I have a failing Catalyst 3548 in a gigastack array. Was recommended to the 2960 but it does not have ports to use the gigastack module. What 1000T devices will plug into my existing 100t/gigastack backbone environment.Thanks

Hi ,when i do sh spanning-treeVLAN0001 Spanning tree enabled protocol ieee Root ID Priority 32769 Address 000b.be50.ed40 This bridge is the root Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec ...

hi everyone, i have two enet port on this router fe0/0-10.116.144.1 fe0/1-10.16.144.17. issue is i have a pc1 connected with .5 and pinging the router fe0/0 interface and pc1 was successfull from the router.however for pc2 connected with .21 i could ...

I've a Cisco Catalyst 6507 with a Supervisor Engine 720 10GE "VS-S720-10G".It is connect with 10G to a Cisco Catalyst 6509 that run a Supervisor Engine 720 "WS-SUP720-3B" and a CEF720 4 port 10-Gigabit Ethernet "WS-X6704-10GE".My Catalyst 6507 has cr...

How come when i set the fastethernet 0/1 for router to full duplex and connect it to the switch (full duplex also), the interface will down? It can only be up when set fastethernet 0/1 to half duplex?

Hi, I have formated MSFC2 bootflash by mistake and try to get new boot file at MSFC bootflash. I can't see "xmodem" command at my RP rommon. How can i restore my MSFC2 bootflash files. my rommon software is running 12(1).Thanks.

Hi all,im cofinguring my Layer 3 switch to forwarding DHCP broadcasts to 2 DHCP servers, 192.168.0.1 and 192.168.0.2. I put the command "ip helper-address 192.168.0.1" "ip helper-adress 192.168.0.2" on the interface vlan. The question is: For wich DH...