i ask silly question.but to save time i ask it.i want cisco switch cheaper than 3560 switch.I need POE and 10/100/1000 speed must.ok? pls reply.regards.
I have two 3750 switches stacked. I created a vlan givingvlan 10name testthen i gave the vlan 10 an interface ip address."interface vlan 10ip add 10.20.4.1 255.255.255.0"BUT the problem is I cant ping this inteface even being inside the switch.There ...
hi all,how can i disable sniffer from the switch ? is there any option inside the switch that would disable/drop .... these sniffing app ? so that they can not read everything on the network ?
I have installed the SDM and the SDM demo software to test using the SDM. I followed the SDM demo instructions, to use 127.0.0.1 as the loop-back IP so as to use the demo. But I get the message "Unable to Launch SDM".One error suggestion is the wrong...
I'm designing and configuring a new network and I would like to connect one router with two interfaces to the same spanning tree domain (a couple of switches). A third interface is going to another subnet.I would like to have the two interfaces to be...
Dear sir, I have 2 juniper routers j-2300. 1)which cable is suitable for that. 2)other end of the cable is connected with the satellite modem which has a 37 pin out female point
Hi. I just wish to ask the difference between clockrate and bandwidth. I mean if i have a line provider of 1024 then my bandwidth is declared as 1024 in my router interface but does that mean that my clock rate is also 1024?Thanks in advance.
Hi all, we have just had a router and asa installed on our network, the asa terminates site to site tunnels to our other buildings, if the router is already natting to an internal address of the firewall, do we still need to do no nat for the site to...
I'm designing a metro fiber ring (1000 mbps) that will have a 9-10 hop diameter. IEEE says no more than 7 hops, but a colleague says that was recommended with 10 mbps links in mind. Any thoughts on STP failing if I have the extra hops on the gig ring...
What is the preferred method of connecting a 2 link channel group at Layer 3 between a 6513 wunning the Hybrid OS and a 6513 running the Native IOS? Thanks for your suggestions.
Good evening,I am working on an issue where a high amount of broadcast data (15Mbps~) on a vlan on a single 3750 with an SVI is causing the switch's cpu to run at near 100% all day.The users on this segment need to be routed to the internet etc, but ...
Machines won't renew (without a release) IPs against a Cisco DHCP servers that dont yet have bindings? Any documentation explaining this would be appretiated
Hi,I'm configuring the network as seen in the attachment.I would like to have one rapid spanning tree domain per vlan. But I'm not quite sure if the routers also support rpvst+ or just pvst+. The core is running rpvst+. The routers seem to adapt to t...
