Switching

Hi,This switch is using the CATOS for layer 2 and IOS for Layer 3, So currently the CATOS is running well but the Layer 3 in the ROMMON, pls refer to below:rommon 1 > boot sup-slot0:c6msfc-dsv-mz.121-27b.E1.binan alternate boot helper program is not ...

Hi,I have a network with GSR and 7600s as ABR and 10720s as internal routers. All are connected using SRP rings.I could see frequent OSPF txretransmit traps on the NMS whenever there is an LSA update. As the network is less than 20% utilized I could ...

Hello,I've a tricky issue on a very simple configuration, maybe you can turn my light on it :I've got this :(VLAN 1 is the default vlan)Router 6xxx ===TRUNK===gi0/1 SWITCH L2 fa0/3---VLAN100---- F0/2/0 HWIC 2811On the 6xxx :int vlan 100ip address 192...

Port 1-7 have access points connected to them Port 8 is connected to a cable modem used for guest wirelessPort GI0/1 is connected to another cisco switch and is used for internal secure wirelessThe vlan's are not working correctlyAttached is the swit...

Hi all, can anyone tell me what unregistered frames are ?

Hi I need help configuring QOS on cisco 3750 switch. I was previously using 2950 and that needs replaced by these 3750 and the QOS configured on the new 3750. Global configurationmls qos map cos-dscp 0 8 16 46 46 46 48 56mls qosInterface configuratio...

Pls, help asap. I have got problems with login into a switch. I have just copied and pasted the Telnet pw as given. It reported "bad password" each time. I don't know what that "7" here means. I want to believe is the user number.hostname CSIGBN08en...

Here is what I have built:ip access-list extended QA210 permit ip any 10.98.6.0 0.0.1.25520 deny ip any 192.168.0.0 0.0.7.255 log30 deny ip any 10.98.0.0 0.0.255.255 log40 permit tcp any any eq www50 permit tcp any any eq smtp60 permit tcp any any eq...

Is't possible to install NAM module into Cat650x/760x without shutdown device?

Hi, We are redesigning our network from scratch. We are hosting our devices at a datacentre which is around 500-700 mtrs away from the HO. There will be a fiber running from the DCR to the HO. Total Users on the network will be around 70-100 and they...

Hello Can someone tell me how I can verify that unicast flooding occurs on a 4500 catalyst with ios?

Hi, I have got a simulation in BSCI exam. i.e. redistribution between OSPF and EIGRP. But when I have given EIGRP 100, the system was showing AS must be 13652. but there did not mentioned any AS no. in the question, so i think I can take any no. Can...

Hi,We are redesigning our network from scratch. We are hosting our devices at a datacentre which is around 500-700 mtrs away from the HO. There will be a fiber running from the DCR to the HO. Total Users on the network will be around 70-100 and they ...

I know that, to avoid the scenario "Dual-Active", is necesary to configure the PAGP. Do I have to do it on the PortChannel from the VSS to Distribution. ???

Hi all,Does anyone have any in depth information or official document about how ISSU works with VSS in conjunction ?Thanks in advance.Cheers.