Switching

Hi all, is there a standard what most people use for there colour of cat 5 cables, ie , crossovers, routers, clients etc ?

is there any Commands Must be enabled on the 6509 Sup 720 regarding Win Vista Networking to work properly???

hii have configured VLANs on cisco catalyst 2924XL, the issue is that when i enable the trunk mode its status goes down...any idea y?

Hi all, can anyone tell me if you can have a port that is a tagged member of say vlan 10 and an untagged member of vlan 5 ? I have seen this on nortel switches on a normal access port ? i would of thought this would be classed as a trunk port ?

Is there some tcpdump'like reliable packet sniffing tool in IOS?I tried to use "debug ip packet", but it doesn't dump traffic, passed over NAT.

Hi all, can anyone enlighten me on how this works through firewalls, does it tunnel through port 80 or something ?

R1#sh ip bgp 170.190.140.0 255.255.255.0BGP routing table entry for 170.190.140.0/24, version 1324996Paths: (2 available, best #2, table Default-IP-Routing-Table)Multipath: eBGP Not advertised to any peer 64806 64872 64852 64851 64871 64811 65531 6...

Hi,1. I have a Catalyst 6509 with FlexWAN & ATM OC3 module. Last week this switch reloaded. All configuration back exceptd ATM module configuration. The ATM module configuration was exist at "show start", but not exist at "show runn". I copy ATM modu...

Ok, Ive been reading that vlan 1 is a security issue and you should not use it. So Im moving all my switchports to another vlan. Im also going to use vlan 14 for my network and system infrastructure devices, ie switches, ap's, servers, and printers...

HiI have a new 128Kbps Telecom ISDN link installed between two of our branch offices as a backup purely for data.The routers on both end are cisco 1841 with Cisco IOS Software, 1841 Software (C1841-IPBASE-M), Version 12.4(1c) and flash is "flash:c184...

Thanks for reading my post. I'm new to Cisco admin'ing and need some help. We currently have a T1 that comes into our offices for servers and an internet connection. Its running off a 4000 cisco series as the outside router and then a 4500 series ...

hi, can anyone tell me where I can find useful configuration sample? eg, bgp configuration sample?

Does anyone have experience configuring the IBM blade server switch (running Cisco IOS ) and configuring it to work with any other Cisco uplink switch? I am having some issue with configuration and need to understand how the port mapping and failover...