Switching

I have 2 6500 (one is a WS-C6509-E and the other is a WS-C6509). I try to connect between them in port channel with 2 connection in gigaethernet...But i have received this error:Mar 19 11:49:42: %STANDBY-3-DUPADDR: Duplicate address 192.168.104.29 on...

Hi All ,Is there any command in switch which shows all the ip address alloted to the computers attached with the switch or ip address alloted for computers under particular VLAN .

I am consoleing into a 1800 seris router.If i do a show clock it shows the correct time. When i see events being logged on the console (IE: a link going up/down) It shows the time as incorrect. It is not applying the correct timezone. Example.If a li...

to use RSPAN on LAN, I used two Catalyst 3560.on the first I did the configuration:monitor session 1 source vlan 1monitor session 1 destination remote vlan 901on the second switch I did the config:monitor session 1 source remote vlan 901monitor sessi...

I want to make the balancing of outbound of two ISPs. I made the following configurations, but he did not function. somebody can help me?int s0: ISP-1int s1: ISP-2eth0 10.10.10.1/24mail server 10.10.0.2proxy/ftp server 10.10.0.3---------------------B...

Hi,I have a few Cisco 6509s with Febric Enabled cards. I would like to enable NSF-SSO redundancy between the Sup720 but the document says following."With a Supervisor Engine 720 and Release 12.2(18)SXE and later releases, if all the installedswitchin...

Hi all, when making redudant routers, is using hsrp more used for defaukt gateways, as on a wan link using a routing protocol would achieve the same thing !

I want to know the stabality of 12.2(18)SXD7b version for a 6513 with Sup2 module.

I have just purchased a 2811 rtr with an nm-cem-4te1 module and it seems that it does not come up during the boot proccess?I loos like the it on the 2811 that 1 is the slot number?thanks for your help

HiFor me to be able to configure QoS, VoIP, telephony, do I need the ipbase or enterprise version of the images?This is a Cat4510?Thanks

Dear Friends,I need exactly the CLI based commands to configure the following scenario:I have Four Catalyst 2955 Switches with Enhanced Image software and all four switches are connected in Mesh Topology and Running RSTP (Rapid Spanning Tree Protocol...

Hi all, can anyone tell me why creating an access list allowing an ip subnet to another one through my firewall would not let me connect remotely to the pc, until I added the tcp port of the program in, I thought ip would of covered this ?cheers

My boot varaible on my 6509 is as under:BOOT variable = bootflash:cat6000-sup2k8.8-6-1.bin,1;bootflash:,1;CONFIG_FILE variable = slot0:switch.cfgConfiguration register is 0x10fignore-config: disabledauto-config: non-recurring, overwrite, sync disable...