Switching

Hi Everyone,I have a rather large network but this problem can be shown with just a single MSFC and L3 3750G.I have two static routes on the MSFC (10.225.0.0/17 and 10.225.128.0/17). I have the following command to redistribute these routes into OSPF...

I need assistance configuring two Cisco 2950 24-port switches for a VoIP phone system utilizing 2 VLANs.Our current configuration is partially managed by Verizon. The two managed devices are a Cisco 2811 router and a PIX 501 firewall. For data, port ...

We have a small issue on the new trading floor switches; sclisgh011, sclisgh012, sclisgh111, and sclisgh112 (all Cat 6500, dual-redundant supe 720, with10G uplinks and 240 * 1G access ports). These devices are configured as layer-2 switches, and in...

Dear AllI configured cisco S/W 2950-24ports and changed the default ip from 10.0.0.1 to 10.10.1.12, now i want to manage the switch from explore by pointing to this new IP. it prompt for level 15 user name and password. can any one let me know what i...

I have 2 PIX firewalls that I am removing and replacing with a router (2811) that has 2 FE ports on it. We're trying to merge networks, but still need to route our traffic and do some static NATting. I'm pretty PIX illiterate, but I'll show you the...

I setup a GRE tunnel between two cisco 3725 routers following http://www.cisco.com/en/US/tech/tk828/technologies_configuration_example09186a00801a5aa2.shtmlThey are both running IOS c3725-ipbase-mz.123-9e.bin. When I do a show ip int brief they both ...

Hello,I have to configure a cisco 1721 with NATthis is the config :sh runBuilding configuration...Current configuration : 1899 bytes!version 12.3service timestamps debug uptimeservice timestamps log uptimeno service password-encryption!hostname ByPas...

Hi all, can anyone give me some baseline parameters for packets per second on a lan, as when Im monitoring I need to know what an acceptable and unacceptable amount of traffic is ??please help

Hi,Can I use this wic into my cisco 2821?Best regars

PBR is configured on a Cisco Catalyst 3560 Switch. The Switch is running with c3560-ipservices-mz.122-25.SEE2/c3560-ipservices-mz.122-25.SEE2.bin" Image. However while applying the PBR on the vlan interface, though it takes the command. However the ...

there are R1 and R2 connected by bgp.R2 send bgp community as no-export. in this case, has anyone known how to display community that it exactly set and advertised by command ?i can see in R1, but i would like to see in R2.

I would like to build a very simple network with a switch divided up into 4 vlan's and a single uplink to a firewall. I would like to assign bandwidth to each of these vlan's. What is the best approach to take for this?