Switching

Hi,I need to configure an access-list that will permit a workstation to browse specific website only and will deny all traffic.The router is configured as the dhcp server. I will create an ip-to-macaddr reserveration for that workstation.What I need ...

I have a requirement where the same data goes to two locations. It is not multicast. Do you know of an appliance that would take a unicast stream and send to two different unicast destinations?

I'm about ready to ramp up multicast throughout our enterprise and was wondering if there is a 'Best Practice' for limiting certain multicast groups.Or is there a Best Practice for multicast in general?

We are currently using 3560's, we are having intermitant connections drop off, is there a tool or debug I can run on an effected link to try accertain what is going on. The interfaces are dropping off maybe once a day, 3-5 interfaces on a single swit...

Does inband health monitoring passively monitor connections for problems or does it actively poll the servers? The documentation is contadictory. The "health" command seems like an active thing.

When operating in hybrid mode all qos is configured in catos. We are using an ethernet WAN service and need to pass voice over the WAN, however the catos desn't support traffic shaping on ethernet ports, only policing. I should be able to use an aggr...

Hi,C2821 with a Switchcard - I have got to get VTP flowwing between them - the card is known as GI1/0.!!interface GigabitEthernet0/0 no ip address shutdown duplex auto speed auto!interface GigabitEthernet0/1 no ip address shutdown duplex auto speed a...

Hi,Has anyone seen this b4 on a 6509.IOS version is sup-bootflash:s72033-jk9sv-mz.122-18.SXD7a.binGi1/15 cscswhmsd5 USD vla connected trunk full 1000 bad EEPROMGi2/11 cscswhmsd15 ESN connected trunk full 1000 bad EEPROM...

HI Guys!i need the Link to download the Cisco icon for visio .10xs for ur help

Hi: I know this is an older router but I am using in my lab for testing purpose.Origianally I had a problem upgrading the IOS image because I received message from the router saying the system flash not writable. So I found the article describing wha...

LOCATION DESCRIPTIONLocation 1: is my laptop logged into the network.Location 2: has 3 machines with one of them using citrix into location 3Location 3: The citrix serverALL LOCATIONS HAS 1 SWITCH AND 1 ROUTER and the network is managed by verizon.No...

We have a data center appliance that runs RSTP, and connects via a Cisco switch with upstream clients on an upstream VLAN and also connectes with downstream devices through a different downstream VLAN, through the Cisco switch. Our appliance uses two...

I've read in multiple places that you can increase the number of virtual terminal lines by typing "line vty [some high number]". When I try on a 2511 with IOS 12.2 installed, it responds with an error: "Invalid input detected". When I try "line vty...

WHCIH COMMAND IS USED ON CGESM TO COME OUT FROM ROUTED MODE?