Switching

How is calculate the forwarding rate for the 2960-24TT 6,5 Mbps?

Good afternoon. There is a scheme: Cisco AS5350 it is connected on R2 to automatic telephone exchange Alcatel s12. Prompt, why if Cisco AS5350 it is connected on R2 gives only 4 figures calling. (with ISDN Cisco AS5350 gives number calling) It is adj...

I've setup a total of 5 switch in a cluster and wanted to try to managed it using web.But whenever i http to the switch IP, i can't see any option for CSM, I just got the normal page for a single switch.Anything that i need to configure??

Hi All, I have set-up a home lab using a 2514 as an access server to 2, 2620's, 2 2, 2600's, and 2, 2950-C switches. I have configured my 'ip host' table, but I am still unable to access each device. I have an octal cable going from the async...

We are going to use our 4507 switch as our default gateway. we are plaaning to implement vlans for workstations. What i want to achieve is route internet traffic to two independent ISPs from each vlan.Please could someone point me in the right for do...

I need to connect 2 offices about 300km apart, so that the remote office can connect to application on my Windows Server. I know i need a leased line, i also need 2 router to connect the leased line. But since I have ADSL-broadband cum wireless net...

Hi experts!It is possible to get more than 50% bandwith to egrees priority queue?i mean when i use:"srr-queue bandwith shape x 0 0 0"x can't be < 2. This means that i got only 1/2 of bandwith to priority queue.But i have 3 different types of traffic....

Can anybody confirm that these modules (for example, 7600-SSC-400) are CEF720 modules?

which switch models support cat 6 cabling

Dear all,I did using a command " sh inventory" to see my 17xx router serial number as below:PID: C1711 1FE 4ESW Mainboard Port Adopter, VID: 0x101, SN: FOC0942XXXXIs it this SN:FOC0942XXXX a router serial number?Pls advise!!!

I have a switch that integration engineers goofed on the privelege mode password. I cannot get pass user mode. How can I crack this?

hi,we have two border routers, two Cisco 3825 routers one connected to an active T1 and the other to a Shadow T1 with HSRP running between them.my question is this: shouldn't configuration changes on the active router be reflected onto the stand by r...

Hi all,I'm trying to connect a 3560 to the 2960G switch by CAB-SFP but the port goes to the err-disabled because of gbic-invalid.Is anybody have any idea?thnx

Hi,I have configured PBR to create a backup interface. This is done by using a catch all ACL and setting two next hops in the map. It seems to work OK. But I am trying to understand what PBR tests in order to check if the highest priority next hop is...

Hi there,I have a Cisco Catalyst 4507 and supervisor engine IV. The CPU utilization goes up to 99% during most part of the day. I have made some troubleshooting but I found nothing wrong. The performance of the traffic forwarding was not afected. But...