Switching

here at work, a company has installed 2 routers, 1 with a dsl port and the other is an isdn bri router, they have linked it so that it ones fails it uses the isdn router ? they are soho 800 routers, I think one of them is in the lan and then the othe...

Hi all, im Im setting up netflow on my router, the interface is 100 meg, is this 819200 KBits per sec ?

Hey guys,I'm using sdm to do a quick setup on my router i managed to setup using the quick wizard and i setup the pppoe connection but i don't think it's connecting because i am getting dns error when i try to browse. Am i missing a step??? Do i need...

I am planning for dual proxy on a single machine. It mean that On the same squid server there will be two proxy servers running(two interfaces, two ip's and two ports) 172.28.2.19:8080 and 172.28.2.20:808.Currently only IP 172.28.2.19 is NATed to a p...

Hello,I'm trying to setup a 3500 8 port fibre switch to link into the network. I have set up IP address and gone through the default config. Then inserted GBIC module and linked directly into another 3500 8 port fibre with a fibre cable but not getti...

Ok now I know what I need to monitor, what thresholds should I look at for my filters?Is there any best practice guides?How do I know if my switch is under to much load, has to many errors on any one port?Many thanks.Mike.

are these sent put from the root switch every 2 seconds ?

Hello all, This is probably a simple question. I have 3 switches that are gigastacked on top of one another. I would like to assign each switch an ip address in order to manage the switches. Below is more informaiton on the switches. SW1-3550SW2-3550...

Hey guys,I erased my flash by mistake, how do i fix this???This is the error i get when i boot up.device does not contain a valid magic numberboot: cannot open "flash:"boot: cannot determine first file name on device "flash:"???

dear sir, in a vtp domain how many server mode switches should be.what role transpranent mode vtp domain and were we are using it.

Hello all, not sure if this is where I should post this but here goes. I have an 1811W and would like to set each Fast Ethernet port to have its own NAT defined.Here's my reasoning. I am trying to setup a roll-over for my Internet connection. If the ...

In what screen in cisco works, can I set how often it archives my configs, and for how long I want to keep them. Right now it just seems to archive when there is a change made to the config. Thanks.

can anyone please tell me what the difference is, is asa a new name or form of pix ?thanks