Switching

I wish to get my 3750 obtain its clock from a windows 2000 machine.I've told the switch to get its clock from the win 2000 machine using the command "ntp server XX".The output of the show ntp status is below:Clock is unsynchronized, stratum 16, no re...

Hi Guys,I have a 6513(L2/L3) and whan I have a loop-SpanningTree, the switch crash. Than I eliminate the loop-STP, the switch don't give more arp a some server e host.Why?Tank's...and sory for my EnglishMassimo

I am looking for the proper config settings to run a traffic generator into 1 port, then out 3 others with no restrictions. For some reason xmission has been cut short by my catalyst 2900, whereas it should continue flowing through the switch without...

Hi I would really appreciate if someone can help me. I am new to Cisco routers and this is my first time configuring a router. How do I access the router via a PC? I have tried connecting via hyperterminal to no avail. If I telnet through a windo...

Hi Guys, I am seen this error message on a 4000 access switch "%SYS-4-P2_WARN: 1/Traffic from permanent host 00:08:a3:dd:a7:dd but seen on incorrect port 1/2" That mac address is from the switch itself. I don't know much about this type of problems,...

Hi,Can anyone please let me know what are the functionality of AIM Compression modules.What is Wire-Speed technology and how it works.Waiting for earliest responses..ThanksIrshad

I have a Cisco 1720 router and I am able to log in to it via telnet and enable the advanced features. I want to match up one of our external IP addresses to an internal IP address. I guess that I use NAT to do this but I don't know any of the comma...

Hi, Have a Catalyst 2948. I have the ip address of a server which is infected. By which command can I see on which switchport this server is attached? Show cam, sh mac.. I just can't find it...Thx,Peter

Hi all,I have a little question for you.I have a FR 2 Mbits on my serial 1 (1721 router)When i do a show int serial 1 i get the following CAPOROUTER#show int serial 1Serial1 is up, line protocol is up Hardware is PowerQUICC Serial MTU 1500 bytes, ...

Cards and Modules have they names printed on the outside of each card/module... (NM-HD-2V / VIC2-2BRI-NT/TE )Is there a #show command that shows me this information ????ThanksAndrei.

I searched ntp server in google.some result was showed, but I can't find a free NTP server. I wish to configure to our router in NTP because the log's timestamp show to invalid time.I had configured clock set which using to configure equipment time. ...

Hi All,I have just installed a tftp server on my machine for billing purposes for a PBX system.To my surprise i saw 2 routers trying to access this tftp server and request a configuration file.How can i disbale this tftp request on my routers ???Hope...

In our campus we have a network of 192.168.2.0 with cisco switch 2950.A segment called seg-1 is pulgged into switch port - 8(total 5 segments),& our proxy server is plugged into port 3. now what i want is that i want ,to restrict seg1 computers to ac...