Switching

I have a Cisco 837 router and am using Security Device manager to configure it. I have setup a site to site VPN which is going fine.Now I need to allow one of the managers to access his desktop from home using WinXPpro remote desktop.I belive that I ...

Hi!I have recently picked up a Catalyst 2900XL switch at an auction, and was wondering if I could use it as a glorified hub to connect 6 computers in a home setting, as I have outgrown my current dimestore 4-port hub. After cruising the Cisco tech su...

Hi Guys, I have recently acquired a 2504 router for a lab to aid in my CCNA. The router has one token ring port. I need to access the router via this interface so I can tftp an image to it. How do I do this? I have a DB9 to RJ45 adapter, but any atte...

Guys, Very vague question so a vague solution is fine! :)If I wanted to connect 40 Distribution switches , say 3750 with SFP to a 6500 via fiber, would I be able to simply use a 48port SFP module in the 6500 and connect like that?Would the 6500 be ab...

I am replacing Microsoft RRAS with a 2801 router and would like some opinions on how to best configure the connection from the internet to our internal network for internet connectivity and a remote office VPN (1 user).The current setup is:remote PIX...

What is the best way to configure a 2600 router for a point to point using a T1 connection.We have one location in the midwest of the USA and one located on the east side. I figure once the circuit has been activated, just applying a static route...

We're utilizing the nat feature, where we're nating the destination address of a packet and using the "sh ip nat statistics" to monitor it. The statistics include the number of hits and misses. I understand what the number of hits means, but how shou...

Hello, who can explain the use of ip dhcp-server on Catalyst 2950? cat2950-03(config)#ip dhcp-server ? Hostname or A.B.C.D IP address or Name of DHCP server The "Catalyst 2950 and 2955 Cisco IOS Commands": http://www.cisco.com/univercd/cc/td/doc/prod...

What is the difference between a version that is 12.0(7)T and 12.0(7)XE.What do the letters at the end mean?TXEEA1cThanks

Given the command show mac-address-table from the privilege exec mode in a cat 2950, the output shows some (i think 4) mac-address tha are system. Do u have any idea what are these mac?

I currently have a Cat5500 as my core switch and 10 -2948g's (two per floor), connected through fibre. We are purchasing new pc's that come with gigabit nic's and I would like to upgrade my network to allow gigabit to each workstation. Any suggesti...