Switching

Have a simple question, but I can get to the solution, so I'm posting it here. I have one Cisco 827 router and an old Intel 3110 VPN Gateway (and firewall) behind the cisco router. The scenario is this: internet <--> Cisco 827 <--> Intel 3310 <--> LA...

Hi,Just a quick configuration question about EIGRP.Lets say I have 6x 2600 Routers in a ring topology using the Serial interfaces: 2600A -> 2600B, 2600B -> 2600C ...etc... 2600E -> 2600F, 2600F -> 2600A and I want to use the EIGRP routing protocol.26...

Hi there is a tool where you can assambly a device, I mean put the IOS and check if all the components I want are compatibles.Can somebody help to find out this tool. Is free but I can not locate it.Thanks

Can someone please point me to where I can read up on how the switching module is working on blade servers?Thanks.

Hi guys, I am trying to connect to a 2904 router via console able but all I am getting are two characters that look like capital C's and then no more output on the screen. Any ideas as to what i should do next?Thanks

i have a office that connect to a main building and to this office have two wan connection to that building, one adsl and the secound e1 and i want to backup the e1 with the adsl and backup the router tooso what i need to config?thanks

Need help on steps to be followed for revamping the Campus Network Infrstructure.

Good Afternoon,We are running VPN connections across three sites using ADSL. The connections seem to be slow. We have been told data shaping will fix the problem. Can someone point me in the right direction? We are using Cisco 1720 routers and PIX 51...

hi there, I have two cisco 2500 routers, having AUI interfaces. both locations have DSL connection from verizon,. is there anyway i can use these routers with DSL if yes then do i need to buy any special module

Hi on my network a have this segment 167.175.60.0 with mask 255.255.255.0. Can I take this segment to do something like 167.175.60.220 mask 255.255.255.252. Can I have this segment with both masks?thanksregards

hi,i have 2 switches; a nortel passport 8610 (all ports are on VLAN 1) and a catalyst 3550 (all ports are on VLAN 4). both swithces are connected via cross cable and each switch has a PC connected to it and the two PCs can ping each other (both have ...

Hi, i have a 2621 with a WIC-E1 for the leased line connection, FE0/0 for LAN and FE0/1 is the second WAN link.Have a tunnel running over the E1 link, now I need a backup solution if the E1 goes down over the FE0/1 interface

Imagine you are hired by a business that needs assistance with their LAN/WAN. There is no documentation and all you have is a laptop and telnet/ssh. How would you go about discovering the network(s) and how things interconnect ? Also, what would you ...

HelloI'm incorporating a technique into our network that uses a dual slot network card. The driver of these cards also makes it so that both NICs have the same MAC. both of the network cards are linked to a cicso 4500 catalyst switch. the link work...