Switching

Hi, I've got a tricky issue with Cisco WS-C2960X-24PSQ-L. It comes brand new; only upgraded software to 15.2(7)E2 and configured a few things (ssh, passwords...) (full config at the end) When I plug anything on uplink (ports 25 or 26), or on PoE port...

Hello all.I've got an issue with memory utilization on 3750x switch. show memory statistic history  command shows that Processor Memory Pool is always 90% used. Original IOS is c3750e-universalk9.mz-12.2.58.SE2.bin, upgraded to 15.0(2)SE7, then downg...

Hi members, does the cat 9300 support VXLAN? The use-case is for vm mobility between two locations.  Thnx 

Where is the documentation for the Cisco AGS (Cisco Advanced Gateway Server)? This was Cisco's very first router.

hello, how i can calculate the electrical load of cisco switches ?? Regards,

We upgraded a cisco 45xx series switch. We accidentally used a image that did not have crypto config in it (K9 was missing). So we could not SSH into device after upgrade however we were able to telnet.Why did the device allow us to telnet when we ha...

Hello, I have a switch witch some port changing state randomly...like this: Jul 24 14:58:59.374 CEST: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet1/0/3, changed state to downJul 24 14:59:00.378 CEST: %LINK-3-UPDOWN: Interface Gigab...

On a ASA there is an OSPF external route which is in the OSPF database. The associated ASBR is reachable but the route is not appearing in the routing table.There is another router which is 1 hop closer to the source of the external route and the rou...

Since the documentation does not make it clear imo - I assume when preparing a switch to join an existing stack, the provision command must be applied to the master, and not on the switch to be added?thanksAjaz Nawaz