Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Get 20% off switches when you combine Cisco solutions

 
Labels

Forum Posts

Hi guys!I have a router (2811) configured to NAT addresses between my internal network and the internet.If I connect my laptop straight to the internal network port (FE0/0) I am unable to ping to the internet, but if i try to ping from the router it'...

HI ,i wold like to know about layer 2 switch loopback interface unreachable problem.i have the 2960 lanbase switch. I would like to create loopback interface for some purpose.i have the one vlan. let say vlan id is 10. i would like to get connectivit...

MrBeginner by Spotlight
  • 1936 Views
  • 3 replies
  • 0 Helpful votes

I have a cisco sg200-10fp layer2 ,the power led is blinking, but the, Ethernet ports are not coming up, sometimes it comes up and after 15mins they go off again, any hints that might be causing this?

nkirui by Level 1
  • 551 Views
  • 4 replies
  • 0 Helpful votes

We have 2 9300's in a stack and are noticing a large amount of Total output drops on the interfaces.  Every up port seems to have output errors and even after a clear interfaces stats....but the output drops increase even with Minimum load. We also h...

joeharb by Level 5
  • 748 Views
  • 2 replies
  • 0 Helpful votes

One of our clients wants to upgrade their core devices, currently they are connecting to the other Switches at 10G, but will upgrade the other devices next year to 40G.Is it possible to configure the interfaces of the C9500-32QC, to run at 10G and us...

Hi I'd like to know if it would be possible to simulate broadcast streams in Cisco cml?  so I I had 2 offices 3 switches at each office and a router on each end connecting the wan. I doubt it tbh, but thought I'd just ask. Cheers